Interior Modern Lever Latchset with Modern Round Rose - Solid Brass Dimensions: 2-1/2" Projection x 4-3/4" Length Finishes: US3, US10B, US14, US15, US26, US26D, TB...
Search Results "Counter Length"
Filters
Commonly Searched Documents
-
Omnia Industries Inc. Interior Modern Lever Latchset with Modern Round Rose - Solid Brass No.930MD
-
Magnuson Group CLM Series Coat Rack
Available in 2, 3, or 4 foot lengths....
-
American Specialties Automatic Roll Paper Towel Dispenser and Waste Receptacle 04692A
Proximity sensing no-touch unit dispenses a pre-set length per cycle from 8" or 9" (205 or 230 mm) wide, 800' (244 m) long rolls. Battery operated (4) D-size....
-
Definitions of residential facilities and transient lodging. (Section-by-Section Analysis)
including "primarily long-term" and "primarily short-term" in the respective definitions creates confusion when applied to the listed facilities because they serve people for widely varying lengths...
-
Definitions of residential facilities and transient lodging. (Section-by-Section Analysis)
"primarily long-term" and "primarily short-term" in the respective definitions creates confusion when applied to the listed facilities because they serve individuals for widely varying lengths...
-
Recommended Objective Test Method and Performance Specifications
Surfaces that are firm, but only moderately stable should be allowed on linear trails less than 0.5 mile in length (i.e., do not require a lot of turning or pivoting)....
-
11B-604.5.2 Rear wall
The rear grab bar shall be permitted to be 24 inches (610 mm) long minimum, centered on the water closet, where wall space does not permit a length of 36 inches (914 mm) minimum due to the...
-
11B-604.5.2 Rear wall
Exceptions: The rear grab bar shall be permitted to be 24 inches (610 mm) long minimum, centered on the water closet, where wall space does not permit a length of 36 inches (914 mm...
-
IDEA Center
Analysis of individual participants with very large measurements for length identified two clear “outliers” who were excluded from the sample....
-
5. Voice Carryover and Hearing Carryover
These types of communication can shorten the length of calls that would otherwise be conducted exclusively by typing....
-
11B-405.8 Handrails
At door landings, handrails are not required on ramp runs less than 6 inches (152 mm) in rise or 72 inches (1829 mm) in length....
-
302.2 Carpet
Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge. Carpet edge trim shall comply with 303....
-
1007.2 Accessible Routes
Ramp landing length specified by 405.7.3 shall be permitted to be 48 inches (1220 mm) long minimum. 6....
-
604.5 Grab Bars
Reinforcement must be sufficient to permit the installation of rear and side wall grab bars that fully meet all accessibility requirements including, but not limited to, required length,...
-
Benches [1011.2]
Although there are no technical requirements for the bench itself, providing a bench with at least one armrest and back support that runs the full length of the bench is helpful to people...
-
Parallel Curb Ramps (R304.3) (Section-by-Section Analysis)
A minimum running slope of 5 percent and a maximum running slope of 8.3 percent are specified for parallel curb ramps, and the ramp length is limited to 4.5 meters (15 feet)....
-
302.2 Carpet
Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge. Carpet edge trim shall comply with 303....
-
1007.2 Accessible Routes
Ramp landing length specified by 405.7.3 shall be permitted to be 48 inches (1220 mm) long minimum. 6....
-
Redundant alt-text (now hear this… twice)
There is a long handle running the length of Pastel’s back. This is the handle that the handler uses to follow Pastel’s movements....
-
302.2 Carpet
Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge. Carpet edge trim shall comply with 303....
-
1134A.7, Item 2
The backing shall be a minimum of 40 inches (1016 mm) in length....
-
Recessed Lavatories
In-swinging doors must clear fixture clearances and door clearances must clear the water closet fixture (verify toilet length)....
-
F216.13 Trailhead Signs
The technical requirements in 1017.11 require the signs to include information on the length of the trail or trail segment; surface type; typical and minimum tread width; typical and minimum...
-
Clear Floor Space: Minimum Clear Floor Space Required - Manual, Power & Scooter
Dimensions are based on length and width measurements obtained from occupied wheeled mobility devices as part of the Anthropometry of Wheeled Mobility Study....
