[See subsections ...]
Search Results "Pedestrian Route"
Filters
Commonly Searched Documents
-
401 General
-
11B-401 GENERAL
[See subsections ...]
-
A4.3.1 General
[See subsections ...]
-
A4.3.1 GENERAL
[See subsections ...]
-
11B-401 General
[See subsections ...]
-
11B-401 General
[See subsections ...]
-
R302.3 Continuous Width
Except as provided in R302.3.1 and R302.3.2, the continuous clear width of pedestrian access routes shall be 1.2 m (4.0 ft) minimum, exclusive of the width of the curb....
-
Pushbutton locator tone
locator tone The pushbutton locator tone is a low-volume tick or tone that repeats constantly, at one-second intervals, during the flashing and steady DON’T WALK intervals to advise pedestrians...
-
Location
Source: NCHRP Web Only Document 117-A, Accessible Pedestrian Signals: A Guide to Best Practice, Figure 6-8 Figure 4: Installation of APS on two separated poles, aligned with crosswalk...
-
R202.1 General
Where elements are altered or added and the pedestrian circulation path to the altered or added elements is not altered, the pedestrian circulation path is not required to comply with R204...
-
Issue 8: Rest-in-WALK (quiet time ok)
Issue 8: Rest-in-WALK (quiet time ok) In some locations, the pedestrian signals ‘rest-in-WALK’ and it may not be desirable to have the WALK indication repeat constantly during the long...
-
Synthesis of Literature Relevant to Roundabout Signalization to Provide Pedestrian Access - Final Report
Prepared by: Vaughan W. Inman Science Applications International Corporation and Gregory W. Davis Federal Highway Administration, RD&T 6300 Georgetown...
-
Newly Constructed Tabled Intersections That Contain Pedestrian Street Crossings With Yield or Stop Control (Section-by-Section Analysis)
applies to pedestrian access routes within pedestrian street crossings with yield or stop control where vehicles slow or stop before proceeding through the intersection....
-
ACCESSIBLE ROUTE
Interior accessible routes may include corridors, hallways, floors, ramps, elevators and lifts....
-
R209.2 Alterations
Existing pedestrian signals shall comply with R209.1 when the signal controller and software are altered, or the signal head is replaced....
-
Issue 3: Which signal? Speech WALK messages necessary
Pedestrians standing at one crosswalk could mistake the message of the other crosswalk for their indication to begin crossing....
-
R302.5 Grade
Except as provided in R302.5.1, where pedestrian access routes are contained within a street or highway right-of-way, the grade of pedestrian access routes shall not exceed the general grade...
-
Pushbutton-integrated APS
(See Interfacing Accessible Pedestrian Signals with Traffic Signal Control Equipment.) ...
-
Where Required: ADA Standard Section 206.2
Section 206.2 covers the scoping requirements for where accessible route are required in the most current ADA Standards.
-
Gates, Bars, and Berms
Forest Service-constructed barriers on pedestrian travel routes must have a 32-inch minimum width gap or include a route beside them that will permit passage of a wheelchair....
-
Vibrotactile WALK indications
Vibrotactile WALK indications Vibrotactile indications are transmitted by a vibrating plate or arrow on the housing of the pedestrian pushbutton....
-
R302.6.1 Pedestrian Street Crossings Without Yield or Stop Control
R302.6.1 Pedestrian Street Crossings Without Yield or Stop Control....
-
Issue 13: Stub poles
Flexibility in requirements may make it easier to install usable facilities for pedestrians....
-
Issue 12: Audible beaconing
or during every pedestrian phase....