304.3 Size. Turning space shall comply with 304.3.1 or 304.3.2....
Search Results "Wheelchair Size"
-
304.3 Size
-
407.4.8.1.1 Size
407.4.8.1.1 Size. Characters shall be ½ inch (13 mm) high minimum....
-
407.4.6.2.1 Size
407.4.6.2.1 Size. Buttons shall be ¾ inch (19 mm) minimum in their smallest dimension....
-
Section 35.151(g) Assembly areas (Section-by-Section Analysis)
In addition, § 35.151(g)(3) clarifies that facilities may fill in wheelchair spaces with removable seats when the wheelchair spaces are not needed by persons who use wheelchairs....
-
409.4.6.1 Size
409.4.6.1 Size. Control buttons shall be 3/4 inch (19 mm) minimum in their smallest dimension....
-
R404.3 Size
R404.3 Size. Clear spaces shall be 760 mm (2.5 ft) minimum by 1220 mm (4.0 ft) minimum....
-
Standards Specific to Assembly Areas
• Note: This means that access to a wheelchair space cannot be through another wheelchair space, nor can the wheelchair space stick out into the aisle....
-
M305.3.1 Length
Horizontal standing support gripping surfaces shall comply with M305.3.1.1, horizontal standing support gripping surfaces on diagnostic equipment containing a wheelchair space shall comply...
-
Platform Size and Surface
Platform Size and Surface To be part of an accessible route, lift platforms must provide the amount of clear space required for wheelchairs in ADAAG 4.2.4....
-
1008.3.2.1 Size
1008.3.2.1 Size. Transfer steps shall have level surfaces 14 inches (355 mm) deep minimum and 24 inches (610 mm) wide minimum....
-
1008.3.1.1 Size
1008.3.1.1 Size. Transfer platforms shall have level surfaces 14 inches (355 mm) deep minimum and 24 inches (610 mm) wide minimum....
-
407.2.1.2 Size
407.2.1.2 Size. Call buttons shall be ¾ inch (19 mm) minimum in the smallest dimension. EXCEPTION: Existing elevator call buttons shall not be required to comply with 407.2.1.2....
-
Sec.36.308(b) New construction and alterations
The provision and location of wheelchair seating spaces in newly constructed or altered assembly areas shall be governed by the standards for new construction and alterations in subpart...
-
305.3 Size
305.3 Size. The clear floor or ground space shall be 30 inches (760 mm) minimum by 48 inches (1220 mm) minimum. Figure 305.3 Clear Floor or Ground Space...
-
§ 382.38 Seating accommodations
§ 382.38 Seating accommodations. (a) On request of an individual who self-identifies to a carrier as having a disability specified in this paragraph, the carrier shall provide...
-
Chapter 2: Methodology
[See subsections ...]
-
Four Specific Situations in which a Seating Accommodation Must be Provided
Four Specific Situations in which a Seating Accommodation Must be Provided If a passenger self-identifies as an individual with a disability, there are four specific situations...
-
604.8.1.2 Doors
Toilet compartment doors, including door hardware, shall comply with 404 except that if the approach is to the latch side of the compartment door, clearance between the door side of...
-
Theatre Access NYC
Those who are hard of hearing or deaf, have low vision or are blind, who cannot climb stairs or who require aisle seating or wheelchair locations, who are on the autism spectrum or have...
-
604.8.2.1 Size
604.8.2.1 Size. Ambulatory accessible compartments shall have a depth of 60 inches (1525 mm) minimum and a width of 35 inches (890 mm) minimum and 37 inches (940 mm) maximum....
-
M302.2.3 Size
The size of transfer surfaces shall be measured from center points of their opposing sides....
-
ADA and Level Boarding - Q&A on Wheelchairs and Bus and Rail Service
DEPARTMENT OF TRANSPORTATION DISABILITY LAW GUIDANCE
-
Department of Transportation Disability Law Guidance: Use of "Segways" on Transportation Vehicles
By this definition, a Segway is not a wheelchair. ...
-
Section 35.151(g) Assembly Areas (Section-by-Section Analysis)
These platforms cover one or more rows of non-wheelchair seating. ...
