Platform Size and Surface To be part of an accessible route, lift platforms must provide the amount of clear space required for wheelchairs in ADAAG 4.2.4....
Search Results "Wheelchair Size"
Commonly Searched Documents
-
Platform Size and Surface
-
1008.3.1.1 Size
1008.3.1.1 Size. Transfer platforms shall have level surfaces 14 inches (355 mm) deep minimum and 24 inches (610 mm) wide minimum....
-
1008.3.2.1 Size
1008.3.2.1 Size. Transfer steps shall have level surfaces 14 inches (355 mm) deep minimum and 24 inches (610 mm) wide minimum....
-
407.2.1.2 Size
407.2.1.2 Size. Call buttons shall be ¾ inch (19 mm) minimum in the smallest dimension. EXCEPTION: Existing elevator call buttons shall not be required to comply with 407.2.1.2....
-
Standards Specific to Assembly Areas
• Note: This means that access to a wheelchair space cannot be through another wheelchair space, nor can the wheelchair space stick out into the aisle....
-
305.3 Size
305.3 Size. The clear floor or ground space shall be 30 inches (760 mm) minimum by 48 inches (1220 mm) minimum. Figure 305.3 Clear Floor or Ground Space...
-
M305.3.1 Length
Horizontal standing support gripping surfaces shall comply with M305.3.1.1, horizontal standing support gripping surfaces on diagnostic equipment containing a wheelchair space shall comply...
-
604.8.2.1 Size
604.8.2.1 Size. Ambulatory accessible compartments shall have a depth of 60 inches (1525 mm) minimum and a width of 35 inches (890 mm) minimum and 37 inches (940 mm) maximum....
-
M302.2.3 Size
The size of transfer surfaces shall be measured from center points of their opposing sides....
-
Sec.36.308(b) New construction and alterations
The provision and location of wheelchair seating spaces in newly constructed or altered assembly areas shall be governed by the standards for new construction and alterations in subpart...
-
ADA and Level Boarding - Q&A on Wheelchairs and Bus and Rail Service
DEPARTMENT OF TRANSPORTATION DISABILITY LAW GUIDANCE
-
§ 382.38 Seating accommodations
§ 382.38 Seating accommodations. (a) On request of an individual who self-identifies to a carrier as having a disability specified in this paragraph, the carrier shall provide...
-
604.8.1.2 Doors
Toilet compartment doors, including door hardware, shall comply with 404 except that if the approach is to the latch side of the compartment door, clearance between the door side of...
-
Chapter 2: Methodology
[See subsections ...]
-
Four Specific Situations in which a Seating Accommodation Must be Provided
Four Specific Situations in which a Seating Accommodation Must be Provided If a passenger self-identifies as an individual with a disability, there are four specific situations...
-
1009.5.6 Size
Figure 1009.5.6 Size of Transfer Steps...
- Theatre Access NYC
-
Department of Transportation Disability Law Guidance: Use of "Segways" on Transportation Vehicles
By this definition, a Segway is not a wheelchair. ...
-
Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impacts Performance Phase 2: Final Report
Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impact Performance Phase 2: Final Report REPORT PREPARED FOR: U.S ACCESS BOARD, WASHINGTON, DC Authors...
-
Location and Size
The Access Board is considering whether the following technical criteria would be appropriate for the location and size of transfer supports on diagnostic equipment used by patients in a...
-
Section 35.151(g) Assembly Areas (Section-by-Section Analysis)
These platforms cover one or more rows of non-wheelchair seating. ...
-
604.3.1 Size
[ECTCR UFAS 4.16.2, Fig. 28, 4.34.5.2(1), Fig. 47(a)] Figure 604.3.1 Size of Clearance at Water Closets...
-
Scale and size
Scale and size Large scale maps are desirable, but how big is too big?...
-
1. Standing Supports
The MDE Advisory Committee addressed the issue of standing supports for mammography equipment as well as that of standing supports for wheelchair spaces with raised platforms....