Access aisles are required to be nearly level in all directions to provide a surface for wheelchair transfer to and from vehicles. The exception allows sufficient slope for drainage....
Search Results "Perpendicular Transfer"
Filters
Commonly Searched Documents
-
11B-502.4 Floor or ground surfaces
-
11B-903.4 Back support
To assist in transferring to the bench, consider providing grab bars on a wall adjacent to the bench, but not on the seat back....
-
2. Beds
Beds: Providing beds at an appropriate height, generally from 17 to 19 inches, facilitates transfers to and from wheelchairs....
-
§8.50(c)(2)
(2) Where no transfer of property is involved but property is purchased or improved with Federal financial assistance, the recipient shall agree to include the covenant described in paragraph...
-
§104.5(c)(2)
(2) Where no transfer of property is involved but property is purchased or improved with Federal financial assistance, the recipient shall agree to include the covenant described in paragraph...
-
Expert opinion on current literature
The aspects of setup that experts felt were addressed to some degree included vertical transfer distance, transferring across a gap and position of the mobility device relative to target...
-
Swinging Doors and Gates: ADA Standard Section 404.2.4.1
Section 404.2.4.1 covers the current ADA Standards for maneuvering clearances at swinging doors and gates.
-
5.7.1.2 Lift Compatibility Clearance in Base for Imaging Equipment (M301)
Some MR systems currently have detachable tables that can move away from the magnetic field to permit transfer elsewhere....
-
ALIGNMENT OF 19-INCH RECOMMENDATION WITH ACCESS BOARD PROPOSED RULEMAKING
In its proposed rule, the Access Board proposed that the “height of the transfer surface during patient transfer shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum measured...
-
2 [§§ 4.7.2; 4.8.2; 4.1.6(3)(a)]
The arrow in the illustration to the left [below], aligned parallel to the ramp run and perpendicular to the curb, shows where to measure the running slope....
-
Sloped Surfaces
Two slope measurements perpendicular to one another should be taken at each location....
-
Accessible Rides
Accessible Rides Each newly constructed or newly designed amusement ride must provide at least one wheelchair space, or at least one ride seat designed for transfer, or a transfer device...
-
Summary
This analysis focuses only on the adequacy of the proposed transfer surface dimensions as a static seating surface – i.e., no measurements of transfers were recorded....
-
Front grab bar protocol
Subjects first performed a level height transfer in each condition and afterwards performed the variable height portion of the protocol as described previously (e.g....
-
25. No Assignment of Claims
No Assignment of Claims Each of the Plaintiffs, for themselves and as representatives of the Settlement Class, represent and warrant that they have not transferred or otherwise assigned...
-
Subjects
Subjects The target sample required wheeled mobility device users who lived in the community and were able to transfer independently (with or without a transfer board) and who represent...
-
8.4 Improving Data Sources and Research
It is not clear what size surface is truly needed for individuals to transfer comfortably....
-
10.2.1(1)
For water drainage, a maximum slope of 1:50 (2%) perpendicular to the roadway is allowed....
-
604.3.2 Overlap
with 606 shall be permitted on the rear wall 18 inches (455 mm) minimum from the water closet centerline where the clearance at the water closet is 66 inches (1675 mm) minimum measured perpendicular...
-
Adjustable gap protocol
One hundred and fourteen (114) subjects were tested under this protocol and six could not transfer with a gap of any size added between their WMD and the platform in the configuration shown...
-
Side guard protocol
Of the 60 subjects that were able to transfer to a higher level than their own WMD, 98% (59/60), CI[91%,99%] were able to transfer to height of 22” (55.9cm) (Figure 12 and Table 8)....
-
Bathrooms
Some rooms in larger facilities must have a combination roll-in/ transfer shower....
-
M301 Diagnostic Equipment Used by Patients in Supine, Prone, or Side-Lying Position; M302 Diagnostic Equipment Used by Patients in Seated Position
The purpose of these sections is to facilitate independent transfer onto and off of diagnostic equipment by patients with disabilities, including those who use mobility devices or aids,...
-
§382.65(c)(1)
1) On-board wheelchairs must include footrests, armrests which are movable or removable, adequate occupant restraint systems, a backrest height that permits assistance to passengers in transferring...