Wheelchair storage spaces complying with Section 11B-305 shall be provided in or adjacent to unload areas for each required amusement ride seat designed for transfer and shall not overlap...
Search Results "Perpendicular Transfer"
-
11B-1002.5.4 Wheelchair storage space
-
Supports (M301.3, M302.3, and M305.2)
Some supports such as armrests and side rails can be used for transferring and positioning....
-
11B-604.8.1.2 Doors
that if the approach is from the push side of the compartment door, clearance between the door side of the compartment and any obstruction shall be 48 inches (1219 mm) minimum measured perpendicular...
-
11B-604.8.1.2 Doors
that if the approach is from the push side of the compartment door, clearance between the door side of the compartment and any obstruction shall be 48 inches (1219 mm) minimum measured perpendicular...
-
Examination Chair
Diagnostic equipment with a seat in which a patient typically is positioned with buttocks approximately parallel to the ground and shins approximately perpendicular to the ground....
-
Diagonal Curb Ramps [4.7.10]
Otherwise, perpendicular curb ramps should be used....
-
GRAB BAR
A grab bar may also provide support for a user transferring from a wheelchair onto a bench, seat or plumbing fixture. ◼...
-
GRAB BAR
A grab bar may also provide support for a user transferring from a wheelchair onto a bench, seat or plumbing fixture. ◼...
-
Common Requirements (R304.5) (Section-by-Section Analysis)
Grade breaks at the top and bottom of curb ramp runs must be perpendicular to the direction of the ramp run....
-
1002 Amusement Rides
Provisions for amusement rides require either a wheelchair space on the ride, a ride seat designed for transfer, or a device designed for transfer to the ride....
-
Grab bar protocol
transfer....
-
Evaluate and adjust the volume of the Walk indication
Confirm that the Walk indication for each crosswalk sounds closer than the Walk indication for the perpendicular crosswalk....
-
11B-405.3 Cross slope
Cross slope is the slope of the surface perpendicular to the direction of travel. Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
11B-405.3 Cross slope
Cross slope is the slope of the surface perpendicular to the direction of travel. Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
11B-405.3 Cross slope
Cross slope is the slope of the surface perpendicular to the direction of travel....
-
Transit Stops (R308.1) (Section-by-Section Analysis)
Transit Stops (R308.1) (Section-by-Section Analysis) Boarding and alighting areas at sidewalk or street level transit stops must be 2.4 meters (8 feet) minimum measured perpendicular...
-
Protocol C Heights Obtained
Like the two previous protocols the HERL participants transferred lower on average compared to the NDVWSC participants....
-
Protocol A Heights Obtained
The transfer heights obtained in protocol A for both sample groups can be seen in tables E4 and E5. Table E4....
-
810.2.2 Dimensions--Modification to 810.2.2 of Appendix D to 36 CFR Part 1191
810.2.2 Dimensions--Modification to 810.2.2 of Appendix D to 36 CFR Part 1191 Bus boarding and alighting areas shall provide a clear length of 96 inches (2440 mm), measured perpendicular...
-
Expert opinion on the current knowledge
Our review of the literature revealed a small number of studies that directly relate to the influence of transfer setup on performing independent transfers and thus points to a critical...
-
Measures and Procedures
Subjects were asked to exercise sound judgment in performing the transfers and to only do transfers they felt comfortable and safe doing. ...
-
Executive Summary
Performing the task of transferring oneself from one surface to another is highly essential for wheeled mobility device users in order to accomplish everyday activities such as going to...
-
Expert Advice of Medical Practitioners
She stated that a 14 inch high transfer surface on tables and chairs would be ideal to facilitate the safest transfers, noting that 17 inches can be too high for some people. Ms....
-
404.2.4.3 Recessed Doors and Gates
forward approach shall be provided when any obstruction within 18 inches (455 mm) of the latch side of a doorway projects more than 8 inches (205 mm) beyond the face of the door, measured perpendicular...