Changes in level up to 1/4 in (6 mm) may be vertical and without edge treatment (see Fig. 7(c))....
Search Results "Vertical Reference Plane"
-
4.5.2 Changes in Level
-
4.5.2 CHANGES IN LEVEL
Changes in level up to 1/4 in (6 mm) may be vertical and without edge treatment (see Fig. 7(c))....
-
Handrails [§504.6, §505]
A vertical clearance 9” minimum between upper and lower handrails will help prevent entrapment....
-
Where Required: Multi-Story Buildings and Facilities [§206.2.3]
provisions in the Standards still apply to stories and mezzanines not served by an accessible route elevators provided anyway must fully comply (as standard or LULA elevators) vertical...
-
§ 38.23(b)(8) Platform entrance ramp
loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, measured on level ground, for a maximum rise of 3 inches, and the transition from roadway or sidewalk to ramp may be vertical...
-
504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
408.1 General
Limited-use/limited-application elevators shall comply with 408 and with ASME A17.1 (incorporated by reference, see "Referenced Standards" in Chapter 1)....
-
1008.2.6.1 Accessibility
Ground surfaces shall comply with ASTM F 1951 (incorporated by reference, see "Referenced Standards" in Chapter 1)....
-
408.1 General
Limited-use/limited-application elevators shall comply with 408 and with ASME A17.1 (incorporated by reference, see "Referenced Standards" in Chapter 1)....
-
1008.2.6.1 Accessibility
Ground surfaces shall comply with ASTM F 1951 (incorporated by reference, see "Referenced Standards" in Chapter 1)....
-
809.5.2 Residential Dwelling Unit Smoke Detection System
Residential dwelling unit smoke detection systems shall comply with NFPA 72 (1999 or 2002 edition) (incorporated by reference, see "Referenced Standards" in Chapter 1)....
-
Platform Lifts
In new construction, platform lifts are permitted as a means of vertical access to certain spaces, including performance areas and speakers’ platforms (206.7.1), wheelchair spaces in assembly...
-
1.18 Wheelchair space, wheelchair location, or wheelchair seating
1.18 "Wheelchair space," "wheelchair location," or "wheelchair seating" shall mean and refer to a designated space in an auditorium where a person who uses a wheelchair or motorized scooter...
-
Sec. 469.059(b)
the complaint, notify in writing the person filing the complaint that the building or facility is not required to be brought into compliance because of a rule or statute and provide a reference...
-
225(g)(1) Referral of complaint
respect to intrastate telecommunications relay services within a State and certification of the program of such State under subsection (f) of this section is in effect, the Commission shall refer...
-
§104.5(a) Assurances
An applicant may incorporate these assurances by reference in subsequent applications to the Department....
-
504.4 Templates
Where templates are provided, templates allowing content creation that conforms to all Level A and Level AA Success Criteria and all Conformance Requirements in WCAG 2.0 (incorporated by reference...
-
8.4 CARD CATALOGS
Minimum clear aisle space at card catalogs, magazine displays, or reference stacks shall comply with Fig. 55....
-
Detecto 6550 Portable Wheelchair Scale Operation
The 6550's unique vertical fold-up design allows it to be portable, so it may be wheeled to various locations in a clinical facility....
-
Allegion Von Duprin 22 Series Exit Devices
Von Duprin 22 Series Exit Devices offer: 22 Rim Exit Device & Standard Trim 22-F Rim Fire Exit Device & Standard Trim 2227 Surface Mounted Vertical Rod Device & Trim...
-
Clearances
The 80-inch minimum vertical clearance requirement remains for circulation areas and accessible routes in the queue line and load and unload areas....
-
§ 38.113(d)(1) Requirements
Vertical alignment may be accomplished by car air suspension, platform lifts or other devices, or any combination....
-
§ 38.83(b)(8) Platform entrance ramp
barrier used as a ramp, shall not exceed a slope of 1:8 measured on level ground, for a maximum rise of 3 inches, and the transition from the station platform or roadway to ramp may be vertical...
-
§ 38.95(b)(8) Platform entrance ramp
loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, when measured on level ground, for a maximum rise of 3 inches, and the transition from station platform to ramp may be vertical...
