Pole-supported pedestrian traffic-control buttons shall be identified with color coding consisting of a textured horizontal yellow band 2 inches (51 mm) in width encircling the pole, and...
Search Results "Horizontal Exit"
Filters
Commonly Searched Documents
-
11B-703.7.2.7 Pedestrian traffic-control buttons
-
4.28.3(7)
(7) In general, no place in any room or space required to have a visual signal appliance shall be more than 50 ft (15 m) from the signal (in the horizontal plane)....
-
4.9.4(2)
At the bottom, the handrail shall continue to slope for a distance of the width of one tread from the bottom riser; the remainder of the extension shall be horizontal (see Fig. 19(c) and...
-
§ 38.53(d)(1) Requirements
Where new vehicles will operate in new stations, the design of vehicles shall be coordinated with the boarding platform design such that the horizontal gap between each vehicle door at rest...
-
§ 38.173(b)
(b) Where the vehicle covered by paragraph (a) will operate in an accessible station, the design of vehicles shall be coordinated with the boarding platform design such that the horizontal...
-
11B-703.7.2.7 Pedestrian traffic-control buttons
Pole-supported pedestrian traffic-control buttons shall be identified with color coding consisting of a textured horizontal yellow band 2 inches (51 mm) in width encircling the pole, and...
-
SDC Z7500 HiTower Pro Series Actuator Controlled Locksets
SDC HiTower® locksets comply with all national and regional building codes for locking interior office, elevator lobby, exit and stairwell fire rated doors, where the use of electric strikes...
-
4.29.3* TACTILE WARNINGS ON DOORS TO HAZARDOUS AREAS
Such textured surfaces shall not be provided for emergency exit doors or any doors other than those to hazardous areas....
-
1132A.5.2 Strike edge maneuvering space at doors
The width of the level area at the exterior side of the primary entry door and any required exit doors shall comply with Section 1126A. Notes: 1....
-
Re: Co-sharing of Accessible Parking access Aisles by adjacent elevator door allowed?
Pedestrians in the elevator would be stepping directly into a vehicular way upon exiting the elevator cab. How would you address the requirement for detectable warnings? ...
-
HEWI Stationary Support Rail Mono WARM TOUCH
- made of environmentally friendly, chrome-look coated polyamide - with a horizontal, round gripping level - loading capacity 220Lbs. (100 kg) (accessible to DIN 18040) - with corrosion...
-
Takeform Fusion Signage Interior Stairwell Type N
Fire and building code typically requires that stairwells in buildings of three floors or more identify the floor and exit point. Raised text and Braille are not required....
-
Gaps
coordinated with the floors of the load and unload areas so that when the ride is at the load and unload position, the vertical differences between the two floors are within 5/8 inch and the horizontal...
-
R409.6 Gripping Surface
Where provided, horizontal projections shall occur 38 mm (1.5 in) minimum below the bottom of the handrail gripping surface. Advisory R409.6 Gripping Surface....
-
11B-806.2.3.1 Personal lift device floor space
The clear space shall extend to points horizontally 30 inches (762 mm), vertically 7 inches (178 mm) and not more than 12 inches (305 mm) from the head and foot end of the bed....
-
Is there a minimum distance between changes in level?
The standards do not require a minimum horizontal separation between changes in level of a ½” or less....
-
11B-703.7.2.7 Pedestrian traffic-control buttons
Pole-supported pedestrian traffic control buttons shall be identified with color coding consisting of a textured horizontal yellow band 2 inches (51 mm) in width encircling the pole, and...
-
11B-806.2.3.1 Personal lift device floor space
The clear space shall extend to points horizontally 30 inches (762 mm), vertically 7 inches (178 mm) and not more than 12 inches (305 mm) from the head and foot end of the bed....
-
11B-806.2.3.1 Personal lift device floor space
The clear space shall extend to points horizontally 30 inches (762 mm), vertically 7 inches (178 mm) and not more than 12 inches (305 mm) from the head and foot end of the bed....
-
a. Structural Strength
The MDE NPRM proposed to require transfer supports to be capable of resisting vertical and horizontal forces of 250 pounds at all points (proposed M305.2.2)....
-
Prohibition of Discriminatory Practices
FAA's rule on exit row seating says that airlines may place in exit rows only persons who can perform a series of functions necessary in an emergency evacuation....
-
1133B.2.5.2
SECTION 1133B GENERAL ACCESSIBILITY FOR ENTRANCES, EXITS AND PATHS OF TRAVEL 1133B.2 Doors. 1133B.2.5.2 Hand-activated door opening hardware, handles, pulls, latches, locks and...
-
5.9.2.1 Standing Supports on Single Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations
The user can hold onto something for stability when accessing or exiting the scale....
-
1010.1.9.8.1 Delayed egress locking system
An attempt to egress shall initiate an irreversible process that shall allow such egress in not more than 15 seconds when a physical effort to exit is applied to the egress side door hardware...
