Where the operable part is located beyond the leading edge of the maximum protrusion within the length of the vertical reference plane, the operable part shall conform to 407.12.3.2....
Search Results "TTY Cord Length"
-
407.12.3.2 Obstructed Forward Reach
-
Cross Slope
The percentage of rise to length, which is the difference in elevation, when measuring the trail tread from edge to edge perpendicular to the direction of travel This may be expressed as...
-
11B-812.7 Access aisle
Access aisles shall be 60 inches (1524 mm) wide minimum and shall extend the full required length of the vehicle spaces they serve....
-
2.2.1 General Description
Of the three types of ALS described in this document, FM radio systems appear the easiest to install; generally, all that is required is a patch cord between an output from the PA amplifier...
- Shepherd Center’s SCI-Ex App
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
11B-607.2 Clearance
Clearance in front of bathtubs shall extend the length of the bathtub and shall be 48 inches (1219 mm) wide minimum for forward approach and 30 inches (762 mm) wide minimum for parallel...
-
Refuge Islands
"(29) However, recumbent bicycles, bicycles with trailers, and hand cycles all have 85th percentile lengths greater than 1.8 m (6 ft)....
-
Department of Justice
ADA Information Line 800-514-0301 (voice) 800-514-0383 (TTY) Internet address http://www.ada.gov/...
-
For more information
For additional information or to order print copies of these documents, call the ADA Information Line (800) 514-0301 (voice) or (800) 514-0383 (TTY)....
-
For more information
For additional information or to order print copies of these documents, call the ADA Information Line (800) 514-0301 (voice) or (800) 514-0383 (TTY)....
-
§ 36.303(d)(1)(ii)
than an incidental convenience basis shall make available, upon request, public telephones equipped with volume control mechanisms, hearing aid compatible telephones, or text telephones (TTYs...
-
STATE IMMUNITY {35.178}
. • Birmingham, AL • Phone 205/9729100 • TTY 205/9729112 • Fax 205/9729110 www.evanterry.com • email: eta@evanterry.com ...
-
410.6.3.1 PSTN (Section-by-Section Analysis)
This is the current industry standard for TTY signals (also known as Baudot) at the PSTN interface....
-
What types of electrical or communication receptacles are exempt because they serve a “dedicated use”?
Electrical receptacles provided for portable communication devices such as TTYs are not covered by this exception and must comply....
-
505.3 Continuity
Handrails shall be continuous within the full length of each stair flight or ramp run....
-
Landings
Must be as wide as the ramp they connect to A minimum length of 60 inches (1525 mm) If ramps change direction, the minimum landing size must be 60 inches (1525 mm) wide...
-
407.12.3.1 Unobstructed Forward Reach
Where the operable part is located at the leading edge of the maximum protrusion within the length of the vertical reference plane of the ICT, the operable part shall be 48 inches (1220...
-
505.3 Continuity
Handrails shall be continuous within the full length of each stair flight or ramp run....
-
505.3 Continuity
Handrails shall be continuous within the full length of each stair flight or ramp run....
-
1003.2.1 Boat Slips
Where an existing gangway or series of gangways is replaced or altered, an increase in the length of the gangway shall not be required to comply with 1003.2 unless required by 202.4....
-
Slopes and Resting Intervals for Beach Access Routes
Sections of beach access route of any length are allowed to have a running slope ratio of up to 1:20 (5 percent grade) (see figure 37)....
-
11B-1003.2.1 Boat slips
Exceptions: Where an existing gangway or series of gangways is replaced or altered, an increase in the length of the gangway shall not be required to comply with Section 11B-1003.2...
-
1003.2.1 Boat Slips
Where an existing gangway or series of gangways is replaced or altered, an increase in the length of the gangway shall not be required to comply with 1003.2 unless required by 202.4....