Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
Search Results "TTY Cord Length"
-
810.2.2 Dimensions
-
Handrails
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops and sides....
-
Mirrors [4.19.6]
Recommendations:Full-length mirrors that extend up to standard height (74 inches minimum recommended) are a good idea because they serve a broader range of people, including those of short...
-
R208 Detectable Warning Surfaces (Section-by-Section Analysis)
travel because detectable warning surfaces must extend 610 millimeters (2 feet) minimum on each side of the island and be separated by a 610 millimeters (2 feet) minimum length of island...
-
Trail Slopes
Trails or trail segments of any length may be constructed with a running slope ratio of up to 1:20 (a 5-percent grade)....
-
Accessible Route
This suggested approach would be an alternative to the gangway length exceptions and limits in section 1003.2.1 of the 2010 Standards....
- State of California Disability Access Services (DAS) - Digital Access: Websites, Documents & Section 508
- Cornell University Employment And Disability Institute
-
7(2)(b)(vi)
(vi) Bathtubs and tub/showers located in the bathroom provide a clear access aisle adjacent to the lavatory that is at least 2'6" wide and extends for a length of 4'0" (measured from the...
-
B7-b
[ADA Standards § 4.7.2] Yes No Note: 1:12 is one inch of vertical height for each 12 inches of length....
-
1134A.6, Item 3
A clear maneuvering space at least 30 inches in width by 48 inches in length (762 mm by 1219 mm) shall be located outside the shower, flush and parallel to the control wall....
-
E1-1. Accessible Route
Is there an accessible route, at least 36 inches wide that connects the accessible entrance to the voting area (the accessible route may narrow to 32 inches wide for up to 2 feet in length...
-
1134A.6, Item 3
A clear maneuvering space at least 30 inches in width by 48 inches in length (762 mm by 1219 mm) shall be located outside the shower, flush and parallel to the control wall....
-
3.3.1 Research Data
of Veterans Affairs health care providers and groups affiliated with paralyzed veterans’ organizations, so not surprisingly 88 study subjects were men and 24 were women; 54 had spinal cord...
-
Adjustable height/gap protocol
One had a complete spinal cord injury at level L4, weighted 145 lbs, 67” tall, and had been using a manual wheelchair for twenty years and used a transfer board during transfers....
-
3. b. Government Assistance
restribr.htm PDF (192 KB) www.ada.gov/restribr.pdf THE ACCESS BOARD 1331 F Street, NW, Suite 1000 Washington, DC 200041111 Phone: 202.272.5434 (Voice) 202.272.5449 (TTY...
- Mockett PCS74 Dome Grommet with 3 Power
-
2013 & 2016 CBC Answer
Measurement Y1 through Y3 are irrelevant because the code does not require marking to define the "length" of parking per Section 11B-502.2. ...
-
5.4.9 Interruptions Along Transfer Support Gripping for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
The bottom of the transfer support shall have no obstruction affecting more than 20% of its length....
-
R409.3 Continuity
Handrails shall be continuous within the full length of each ramp run or stair flight....
-
Can guards or collars be attached to handrails to prevent skateboard traffic?
surfaces at egress stairs subject to the Standards must be unobstructed on the top and sides and free of sharp or abrasive elements so that users can maintain a continuous grip along the full length...
-
E1-a
Is there an accessible route, at least 36 inches wide, that connects the accessible entrance to all shelter areas (it may narrow to 32 inches wide for up to 2 feet in length)?...
-
§ 37.131(c)(1)
(1) In calculating the full fare that would be paid by an individual using the fixed route system, the entity may include transfer and premium charges applicable to a trip of similar length...
-
11B-226.3 Dining surfaces exceeding 34 inches in height
Where food or drink is served for consumption at a counter exceeding 34 inches (864 mm) in height, a portion of the main counter 60 inches (1525 mm) minimum in length shall be provided in...