extent allowed by legal or site constraints; and shall be connected to streets, sidewalks or pedestrian paths by an accessible route complying with 4.3 and 4.4....
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
Filters
Commonly Searched Documents
-
10.2.1(1)
-
Technical Memorandum TM 2013-20 Valet Parking
TM 2013-20 Valet Parking Effective Date: October 3, 2010 2012 TAS Reference: 208 and 209.4 The 1994 TAS (and 1991 ADAAG) required valet parking facilities to provide...
-
Technical Memorandum TM 2012-05 Safe Harbor
TM 2012-05 Safe Harbor Effective Date: January 22, 2013 2012 TAS Reference: 106.5.57 The following clarifications are provided to address variances issued for...
-
Technical Memorandum TM 2012-07 Press Boxes
TM 2012-07 Press Boxes Effective Date: January 22, 2013 2012 TAS Reference: 206.2.7, Exception 1 and 2 The following clarifications are provided to address references...
-
Technical Memorandum TM 2013-14 Dining Surfaces
TM 2013-14 Dining Surfaces Effective Date: June 1, 2013 2012 TAS Reference: 226 and 902 Dispersion The requirements of TAS 226 and 902 are applicable to fixed or...
-
Technical Memorandum TM 2012-08 Private Clubs
TM 2012-08 Private Clubs Effective Date: January 22, 2013 2012 TAS Reference: 201.1 In accordance with TAS 201.1, the requirements of the Texas Accessibility...
-
4. ACCESSIBLE ELEMENTS AND SPACES: SCOPE AND TECHNICAL REQUIREMENTS
[See subsections ...]
-
Title III Technical Assistance Manual (with 1994 supplement)
[See subsections ...]
-
Appendix D to 36 CFR part 1191 – Technical
[See subsections ...]
-
Transfer Supports (M301.3.1, M302.3.1, and M305.2)
These technical criteria are based on provisions in the 2004 ADA and ABA Accessibility Guidelines for grab bars. Question 18....
-
Armrests (M302.3.2)
Where armrests serve as transfer supports, the armrests would be required to meet the technical criteria in M305.2 for the location and structural strength of transfer supports....
-
10.2.2(1)
(1) Bus stop sites shall be chosen such that, to the maximum extent practicable, the areas where lifts or ramps are to be deployed comply with section 10.2.1(1) and (2)....
-
Section 4.1.6, Alterations (Section-By-Section Analysis and Response to Comments)
Section 4.1.6(1)(j) deals with technical infeasibility. Section 4.1.6(3) contains special technical provisions for alterations to existing buildings and facilities....
-
§ 36.105(d)(1)(i)
(i) The term “substantially limits” shall be construed broadly in favor of expansive coverage, to the maximum extent permitted by the terms of the ADA....
-
§1630.2(j)(1)(i)
(i) The term “substantially limits” shall be construed broadly in favor of expansive coverage, to the maximum extent permitted by the terms of the ADA....
-
§ 35.108(d)(1)(i)
(i) The term “substantially limits” shall be construed broadly in favor of expansive coverage, to the maximum extent permitted by the terms of the ADA....
-
11B-404.3 Automatic and power-assisted doors and gates
An automatic door may be used as equivalent facilitation when it is technically infeasible to provide sufficient strike-side clearance for code compliance, but a power-assisted door may...
-
11B-404.3 Automatic and power-assisted doors and gates
An automatic door may be used as equivalent facilitation when it is technically infeasible to provide sufficient strike-side clearance for code compliance, but a power-assisted door may...
-
F203 General Exceptions
This exception, or "grandfather clause," applies only to individual elements and applies only to the extent that earlier standards contain specific provisions for the required element....
-
Base Support [No specific provision—affects M303.2.4]
at 25 inches or beyond4 to the gantry if needed for additional structural support....
-
R202.3.1 Existing Physical Constraints
existing physical constraints make it impracticable for altered elements, spaces, or facilities to fully comply with the requirements for new construction, compliance is required to the extent...
-
E. M305 Supports
M305 provides the technical requirements for supports on medical diagnostic equipment....
-
Why Design for Accessibility?
Why Design for Accessibility? I) It serves everyone who uses the facilities. A) Not just people with disabilities, but People carrying packages, People...
-
General (R304.1) (Section-by-Section Analysis)
The technical requirements for curb ramps and blended transitions are contained in R304 and adapt the technical requirements for curb ramps in the 2004 ADA and ABA Accessibility Guidelines...