The final rules permits exceptions to the specific provisions in the technical requirements for certain elements and facilities based on the conditions listed in Table 2 under Executive...
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
-
Steps to Minimize Significant Economic Impacts on Small Entities
-
Gaps
However, if compliance with those measurements is not operationally or structurally feasible, operators may use bridge plates, ramps or other devices....
-
Floor Plan of Elevator Cars [4.10.9]
In alterations, smaller car sizes (minimum 47 inch width and 69 inch length) are permitted in cases of technical infeasibility, including where limited by existing shaft configurations (...
-
1014.1 General
This section contains the technical requirements for camp shelters with mobility features....
-
Existing Trailheads [F202.3]
trailheads, if elements or spaces are altered but the circulation path to the altered space or element is not changed, the circulation path does not have to be altered to comply with the technical...
-
(C) NYCT’s interpretation of the ADA and DOT’s implementing regulations is too narrow.
access” be provided in connection with staircase or escalator alterations or additions to only those circumstances where a staircase or elevator did not exist previously and where major structural...
-
Site Selection
or parts of them (whether they comply with the older standards or were built before the passage of the ADA) are altered, then the altered areas must comply with the new standards to the maximum...
-
Scoping [4.1.3(14)]
alterations, this requirement applies where a new alarm system is installed or an existing system is replaced or upgraded; the degree of compliance is determined by the scope of work and technical...
-
Besam SL500 Telescopic Automatic Sliding Door
By utilizing an exclusive “door on door” design, the Besam SL500 telescopic innovative design improves upon inferior suspended track systems by putting the door weight to the structural...
-
Q1.) When a ramp has a maximum slope of 1:12 or 8.33%, is that considered a range of from 0% to 8.33% which would allow no slope greater than 8.33% or is that a simple maximum which would allow a tolerance above 8.33%? Similarly, is a cabinet countertop that can be no higher than 34” AFF a range of from 0” to 34” AFF with no additional height allowed, or is a tolerance allowed for variations in the floor surface or cabinet construction?
The consistent technical assistance on this question has been that both are subject to tolerances....
-
12148(a)(2) Exception
(2) Exception Paragraph (1) shall not require a public entity to make structural changes to existing facilities in order to make such facilities accessible to individuals who use wheelchairs...
-
1018.1 General
This section contains the technical requirements for beach access routes....
-
Facility:
All or any portion of aircraft, buildings, structures, equipment, roads, walks, parking lots, and any other real or personal property, normally used by passengers or prospective passengers...
-
1.1.3.1 Nonstate-regulated buildings, structures, and applications
Except as modified by local ordinance pursuant to Section 1.1.8, the following standards in the California Code of Regulations, Title 24, Parts 2, 2.5, 3, 4, 5, 6, 9, 10 and 11 shall...
-
1.1.3.1 Nonstate-regulated buildings, structures, and applications
Except as modified by local ordinance pursuant to Section 1.1.8, the following standards in the California Code of Regulations, Title 24, Parts 2, 2.5, 3, 4, 5, 6, 9, 10 and 11 shall...
-
1. b. ADA Accessibility Guidelines for Buildings and Facilities (ADAAG)
ADA Accessibility Guidelines for Buildings and Facilities (ADAAG) contains scoping and technical requirements for accessibility to buildings and facilities by individuals with disabilities...
-
G.8. - Does acquiring maintenance or support services for an existing system trigger the requirement for the existing system to meet the Access Board's technical provisions?
New maintenance and support contracts on legacy systems do not require the previously owned EIT to meet the technical provisions of Subparts B or C of the Access Board's standards....
-
§ 36.105(a)(2)(i)
(i) The definition of “disability” shall be construed broadly in favor of expansive coverage, to the maximum extent permitted by the terms of the ADA....
-
§ 35.108(a)(2)(i)
(i) The definition of “disability” shall be construed broadly in favor of expansive coverage, to the maximum extent permitted by the terms of the ADA....
-
III-5.3000 Application of ADAAG
In such cases, the ADAAG standards should be applied to the extent possible. Where appropriate technical standards exist, they should be applied....
-
What accessibility requirements apply to EV charger installation outside of California?
RESPONSE: To the extent that EVCS are a public accommodation or commercial facility they are covered by the federal law of the Americans with Disabilities Act....
-
§ 382.5 Facility
Facility means all or any portion of aircraft, buildings, structures, equipment, roads, walks, parking lots, and any other real or personal property, normally used by passengers or prospective...
-
Modification in policies, practices, or procedures.
The preamble to § 36.302 of the current title III regulation states that the regulatory language was intended to provide the "broadest feasible access" to individuals with service animals...
-
Technical Memorandum TM 2013-20 Valet Parking
TM 2013-20 Valet Parking Effective Date: October 3, 2010 2012 TAS Reference: 208 and 209.4 The 1994 TAS (and 1991 ADAAG) required valet parking facilities to provide...
