Elements located in corners can be difficult to reach from a side approach. Recommendation: Where a side reach is provided, locate elements away from corners in...
Search Results "Expected Maximum Flight Duration"
-
Side Reach Radius
-
11B-308.3 Side reach.
[See subsections ...]
-
11B-308.3 Side reach
[See subsections ...]
-
Obstructed High Reach
The maximum high reach is reduced to 46” when the reach over an obstruction is deeper than 10” (to a maximum of 24”)....
-
308.3.1 Unobstructed
Where a clear floor or ground space allows a parallel approach to an element and the side reach is unobstructed, the high side reach shall be 48 inches (1220 mm) maximum and the low side...
-
Figure 308.3.1 Unobstructed Side Reach – Drawing from the U.S. Access Board
-
1 - Design and drawing
If the value is a minimum or maximum or a range, this fact may not be communicated to the contractor, who may think that there is a tolerance ed....
-
Obstructed High Reach: ADA Standard Section 308.3.2
Section 308.3.2 covers the current ADA Standards for obstructed high side reach.
-
11B-308.3.2 Obstructed high reach
and the depth of the obstruction shall be 24 inches (610 mm) maximum....
-
11B-308.3.2 Obstructed high reach
and the depth of the obstruction shall be 24 inches (610 mm) maximum....
-
Minimum Required Depth: ADA Standard Section 306.3.3
Section 306.3.3 covers the current ADA Standards for the minimum required depth for knee clearance.
-
Slope: ADA Standard Section 810.2.4
Parallel to the roadway, the slope of the bus stop boarding and alighting area shall be the same as the roadway, to the maximum extent practicable....
-
11B-810.2.4 Slope
Parallel to the roadway, the slope of the bus stop boarding and alighting area shall be the same as the roadway, to the maximum extent practicable....
-
11B-810.2.4 Slope
Parallel to the roadway, the slope of the bus stop boarding and alighting area shall be the same as the roadway, to the maximum extent practicable....
-
§104.23(b) Alteration
behalf of, or for the use of a recipient after the effective date of this part in a manner that affects or could affect the usability of the facility or part of the facility shall, to the maximum...
-
3.3.15.3 Side (lateral) reach – over an obstruction depth of 610 mm
The results suggest that the recommended maximum depth of 610 mm (24 in.) obstruction would need to be reduced significantly in order to accommodate a majority of our study’s WhMD users....
-
407.12.2.1 Unobstructed Side Reach (Section-by-Section Analysis)
Section-by-Section Analysis) This section proposes that, where the operable part is located 10 inches or less behind the vertical reference plane, the operable part must be 48 inches high maximum...
-
III-6.1000 General
accommodation or commercial facility is begun after January 26, 1992, that alteration must be readily accessible to and usable by individuals with disabilities in accordance with ADAAG to the maximum...
-
General [4.1.6(1)]
Compliance is required in either case to the maximum extent it is "technically feasible."...
-
Alterations: ADA Standard Section 233.3.4
Section 233.3.4: covers scoping requirements in the current ADA Standards for alterations to residential facilities.
-
TECHNICALLY INFEASIBLE
[DSA-AC] An alteration of a building or a facility, that has little likelihood of being accomplished because the existing structural conditions require the removal or alteration of a...
-
TECHNICALLY INFEASIBLE
[DSA-AC] An alteration of a building or a facility, that has little likelihood of being accomplished because the existing structural conditions require the removal or alteration of a...
-
§8.32(e)
If the design of a facility was commenced before July 11, 1988, the provisions shall be followed to the maximum extent practicable, as determined by the Department....
-
§ 37.43(f)(1)
alterations necessary to make a path of travel to the altered area fully accessible is disproportionate to the cost of the overall alteration, then such areas shall be made accessible to the maximum...
