The cross slope of the pedestrian access route within the pedestrian street crossing is the longitudinal grade of the street being crossed, and the 2 percent maximum cross slope requirement...
Search Results "Finished Grade"
Filters
Commonly Searched Documents
-
Newly Constructed Tabled Intersections That Contain Pedestrian Street Crossings With Yield or Stop Control (Section-by-Section Analysis)
-
R208.1 Where Required
Pedestrian at-grade rail crossings not located within a street or highway; 4....
-
Sloped Entries
The slope may be designed as zero grade beach or ramp access. With either design, the maximum slope permitted is 1:12 (8.33%)....
-
Appendix F Photos of Trails Provided by Survey Respondents
and fines-recommended surface Northeast Region Virginia Crushed rock with Gravel Pave II-recommended surface Northeast Region Massachusetts Dense grade...
-
4.1.4(5) BUSINESS
Automobile and other motor vehicle showrooms Banks Barber shops Beauty shops Car wash Civic administration Clinic, outpatient Dry cleaning Educational above 12th grade...
-
Department of Justice method
and techniques section of "Survey Tools and Techniques," (www.usdoj.gov/crt/ada/ckstools.htm) the checklist states that slopes can be measured in three ways: with a land survey to shoot grades...
-
11B-810.4 Bus signs
Bus route identification signs shall comply with Sections 11B-703.5.1 _|Finish and Contrast|_ through 11B-703.5.4 _|Character Proportions|_, and Sections 11B-703.5.7 _|Stroke Thickness|_...
-
1134A.8, Item 1
The top of the fixture rim shall be a maximum of 34 inches (864 mm) above the finished floor....
-
Spa
Slip resistant oil finish on wood floors in the spa and bathroom Spa pre-heated with solar panels Thermal mass in the greenhouses to store heat during the day and release...
-
1134A.8, Item 1
The top of the fixture rim shall be a maximum of 34 inches (864 mm) above the finished floor....
-
11B-407.2.2.2 Visible signals
Visible signal fixtures shall be centered at 72 inches (1829 mm) minimum above the finish floor or ground....
-
11B-810.4 Bus signs
Bus route identification signs shall comply with Sections 11B-703.5.1 _|Finish and Contrast|_ through 11B-703.5.4 _|Character Proportions|_, and Sections 11B-703.5.7 _|Stroke Thickness|_...
-
11B-407.2.2.2 Visible signals
Visible signal fixtures shall be centered at 72 inches (1829 mm) minimum above the finish floor or ground....
-
5. Reassignment to a Vacant Position
An employer may reassign an individual to a lower graded position if there are no accommodations that would enable the employee to remain in the current position and there are no positions...
-
29. Admission and recruitment
Under the proposed regulation, overall success in an education program, not just first-year grades, was the criterion against which admissions tests were to be validated....
-
Test Courses & Surfaces
This “access route” was 574.2 ft (175.0 m) in length, and included two 137 ft (41.8 m) sections with grades of 4% to 5% (one uphill, one downhill), and two 30-foot (9.1 m) ramps with grades...
-
602.2 Clear Floor Space
EXCEPTION: A parallel approach complying with 305 shall be permitted at units for children's use where the spout is 30 inches (760 mm) maximum above the finish floor or ground and is 3 1...
-
R406 Reach Ranges (Section-by-Section Analysis)
R406 Reach Ranges (Section-by-Section Analysis) Forward and side reach ranges must be between 380 millimeters (1.25 feet) and 1220 millimeters (4 feet) above the finish surface....
-
(d) Outside surface at entry door
The Guidelines further provide that the finished surface of this area, located immediately outside the entry door, may be sloped for drainage, but the sloping may be no more than 1/8 inch...
-
11B-604.7.1 Dispensers
The outlet of the dispenser shall be below the grab bar, 19 inches (483 mm) minimum above the finish floor and shall not be located behind grab bars....
-
1133A.3 Removable base cabinets
The finish floor beneath kitchen sinks and work surfaces shall be extended to the wall....
-
1133A.3 Removable base cabinets
The finish floor beneath kitchen sinks and work surfaces shall be extended to the wall....
-
11B-604.7.1 Dispensers
The outlet of the dispenser shall be below the grab bar, 19 inches (483 mm) minimum above the finish floor and shall not be located behind grab bars....