Edge protection shall not be required on the sides of ramp landings having a vertical drop-off of ½ inch (12.7 mm) maximum within 10 inches (254 mm) horizontally of the minimum landing area...
Search Results "Horizontal Projection"
Filters
Commonly Searched Documents
-
11B-405.9 Edge protection
-
1007.6 Areas of refuge
elevator lobby is used as an area of refuge, the shaft and lobby shall comply with Section 1022.10 for smokeproof enclosures except where the elevators are in an area of refuge formed by a horizontal...
-
Issue 9: Reach (how far?)
APS should be within the reach range (1.2 m/48 inches vertically, .25m/10 inches horizontally) for an individual who uses a wheelchair (draft PROWAG, R404)....
-
M305.3.2 Height (Section-by-Section Analysis)
For horizontal supports, the MDE NPRM proposed a gripping surface height of 34 inches minimum and 38 inches maximum above the standing surface....
-
M304.2.2 Standing Supports (Section-by-Section Analysis)
equipment with entry and exit that permits pass-through from one end to another to provide one standing support provided it complies with the requirements for standing supports in the horizontal...
-
608.3 Grab Bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor. EXCEPTIONS: 1....
-
608.3 Grab Bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor. EXCEPTIONS: 1....
-
Grade (R302.5) (Section-by-Section Analysis)
Grade is calculated by dividing the vertical change in elevation by the horizontal distance covered, and is expressed as a percent....
-
1.1.12 Ramp cross slope
overall cross slope of ramps by establishing elevations at the extreme edges of the ramp at the top and bottom of the ramp and calculate the cross slope at these two locations using the horizontal...
-
Stairs
At the bottom, the handrail shall continue to slope for a distance of the width of one tread from the bottom riser; the remainder of the extension shall be horizontal (see Fig. 19(c) and...
-
11B-405.9 Edge protection
Edge protection shall not be required on the sides of ramp landings having a vertical drop-off of ½ inch (12.7 mm) maximum within 10 inches (254 mm) horizontally of the minimum landing area...
-
1009.7.2 Separation
The fire-resistance-rated exterior wall construction shall extend horizontally 10 feet (3048 mm) beyond the landing on either side of the landing or equivalent fire-resistance-rated construction...
-
1009.3.3 Area of Refuge
Areas of refuge are not required for stairways accessed from a refuge area in conjunction with a horizontal exit....
-
11B-405.9 Edge protection
Edge protection shall not be required on the sides of ramp landings having a vertical drop-off of ½ inch (12.7 mm) maximum within 10 inches (254 mm) horizontally of the minimum landing area...
-
Bradley Center-Pull Towel Dispenser 2479
Center pull towels Model 2479-000000 - recessed (recesses 11-1/8") Model 2479-100000 - semi-recessed mounted (recesses 3-1/2", projects 8") Model 2479-110000...
-
NFPA
unfinished attic or an exterior wall, smoke alarms and smoke detectors shall be mounted on an inside wall. 4) Smoke alarms or smoke detectors shall be installed a minimum of 20 feet horizontal...
-
11B-502.4 Floor or ground surfaces
Built-up curb ramps are not permitted to project into access aisles and parking spaces because they would create slopes greater than 1:48. ◼ Advisory 11B-502.4 Floor or ground surfaces...
-
Bradley 2.8 Gallon Waste Receptacle
Model 3251, 3251-10, 3251-11 Model 3251 - Recessed Model 3251-10 - Semi-recessed (recesses 2"; projects 2") Model 3251-11 - Surface Mounted (projects 4")...
-
Bradley Round Corners Medium, Capacity Towel Dispenser / 12 Gallon Waste 234
Satin Finish Stainless Steel Holds 800 multi-fold or 600 C-fold paper towels 12 gallon waste capacity Model 234 - BradEX (Recesses 4"; projects 4-3/4")...
-
Lutron Sivoia QS Wireless Shading System
control the entire family of Lutron automated window treatments, including roller shades, Venetian blinds, traditional drapery tracks, Kirbé® Vertical Drapery System, tensioned shades, horizontal...
-
D. What tools are needed to conduct a survey and how do you use them?
The following are the standard tools that the Civil Rights Division uses in conducting its surveys under Project Civic Access: a metal measuring tape that is at least 25-feet long...
-
About the Author
James “Scott” Groenier, professional engineer, began working for MTDC as a project leader in 2003....
-
Documenting Use of the Conditions for Exceptions on a Portion of a Trail or Beach Access Route [F204.4.1]
The documentation should be retained with the project records....
-
Can you provide recommended signage for ADA accessible spaces?
For projects within the public rights-of-way, the California Department of Transportation (Caltrans) has several signs for EV charging in its California Manual on Uniform Traffic Control...
