The system includes fittings, handrails, signage, sanitary accessories as well as accessibility products for the comfortable and convenient bathroom....
Search Results "Handrail Diameter"
Commonly Searched Documents
- HEWI System 100 Door Hardware
-
1015.3 Height
For occupancies in Group R-3, and within individual dwelling units in occupancies in Group R-2, where the top of the guard serves as a handrail on the open sides of stairs, the top of the...
-
1007.3 Stairways
In order to be considered part of an accessible means of egress, a stairway between stories shall have a clear width of 48 inches (1219 mm) minimum between handrails and shall either incorporate...
-
C2‒1
., wall-mounted boxes, signs, handrail extensions) with bottom edges that are between 27 inches and 80 inches above the walkway and that extend more than 4 inches into the sidewalk or walkway...
-
5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2
The provision addresses gripping surface diameter and perimeter of the support. NPRM Proposed Provision: gripping surface cross section not addressed....
-
Revolving Doors or Turnstiles
While automated revolving doors, if large enough, may be usable by people with disabilities, certain questions remain about the appropriate maximum speed, minimum diameter, compartment size...
-
703.3.1 Dimensions and Capitalization
Table 703.3.1 Braille Dimensions Measurement Range Minimum in Inches Maximum in Inches Dot base diameter 0.059 (1.5 mm) to 0.063 (1.6 mm)...
-
Surface, Slope, and Openings [1011.2.2, 1011.2.3, and 1011.2.4]
Openings in the surface of the clear ground space must be small enough so that a sphere more than one-half inch in diameter cannot pass through....
-
Why test on straight courses and P-shaped turning courses?
Constructing long test courses enables comparison of subject data with research done by other investigators in which subjects walk on a straight linear course or in large diameter circles...
-
BCT location
Okay, it might be obstructed by the handrail. Maybe....
-
Ramps
They must meet the ADA's requirements regarding slope, width, landings, handrails, and edge protection....
-
1.1.17 Stairs
For stairs with intermediate handrails take additional measurements approximately 15 in. (380 mm) on both sides of the intermediate handrail....
-
5.3.6 Entrance
Sloped entries do not require handrails....
-
5.3.6 Entrance
Sloped entries do not require handrails....
-
703.3.1 Dimensions and Capitalization
Table 703.3.1 Braille Dimensions MEASUREMENT RANGE MINIMUM IN INCHES MAXIMUM IN INCHES Dot base diameter 0.059...
-
703.3.1 Dimensions and Capitalization
Table 703.3.1 Braille Dimensions Measurement Range Minimum in Inches Maximum in Inches Dot base diameter 0.059 (1.5 mm) to 0.063 (1.6 mm)...
-
Combination Wheelchair/Horse Accessible Gates
The gate dimensions work well together because the required turning diameter for a wheelchair is 60 inches....
-
C. Accessibility Within Toilet Rooms
Is there an area within the toilet room where a person who uses a wheelchair or mobility device can turn around - either a minimum 60-inch diameter circle or a “T”-shaped turn area?...
-
Jogging Strollers
These strollers usually have spoked wheels of about 300 to 500 mm (12 to 20 inches) diameter with pneumatic rubber tires allowing use at higher speeds and over more varied terrain....
- Bobrick Countertop-Mounted Circular Waste Chute B-529
-
Accessible Fishing Piers and Platforms
Sections 237 and 1005 of the 2010 Standards require at least twenty-five percent (25%) of railings, guards, or handrails (if provided) to be at a 34-inch maximum height (so that a person...
-
11 [§ 4.7.6]
Built-up curb ramps should have flared sides with a slope of 10 percent or less or have edge protection and handrails on the sides....
-
11B-303.5 Warning curbs
A warning curb is not required when a guard or handrail is provided with a guide rail centered 2 inches (51 mm) minimum and 4 inches (102 mm) maximum above the surface of the walk or sidewalk...
- GameTime ADA Wide Ramp Attachment 3D