Openings in the surface of the clear ground space must be small enough so that a sphere more than one-half inch in diameter cannot pass through....
Search Results "Handrail Diameter"
-
Surface, Slope, and Openings [1011.2.2, 1011.2.3, and 1011.2.4]
-
Why test on straight courses and P-shaped turning courses?
Constructing long test courses enables comparison of subject data with research done by other investigators in which subjects walk on a straight linear course or in large diameter circles...
-
5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2
The provision addresses gripping surface diameter and perimeter of the support. NPRM Proposed Provision: gripping surface cross section not addressed....
-
5.3.6 Entrance
Sloped entries do not require handrails....
-
5.3.6 Entrance
Sloped entries do not require handrails....
-
Ramps
They must meet the ADA's requirements regarding slope, width, landings, handrails, and edge protection....
-
1.1.17 Stairs
For stairs with intermediate handrails take additional measurements approximately 15 in. (380 mm) on both sides of the intermediate handrail....
-
703.3.1 Dimensions and Capitalization
Table 703.3.1 Braille Dimensions MEASUREMENT RANGE MINIMUM IN INCHES MAXIMUM IN INCHES Dot base diameter 0.059...
-
703.3.1 Dimensions and Capitalization
Table 703.3.1 Braille Dimensions Measurement Range Minimum in Inches Maximum in Inches Dot base diameter 0.059 (1.5 mm) to 0.063 (1.6 mm)...
-
Combination Wheelchair/Horse Accessible Gates
The gate dimensions work well together because the required turning diameter for a wheelchair is 60 inches....
-
C. Accessibility Within Toilet Rooms
Is there an area within the toilet room where a person who uses a wheelchair or mobility device can turn around - either a minimum 60-inch diameter circle or a “T”-shaped turn area?...
-
Jogging Strollers
These strollers usually have spoked wheels of about 300 to 500 mm (12 to 20 inches) diameter with pneumatic rubber tires allowing use at higher speeds and over more varied terrain....
-
Bobrick Countertop-Mounted Circular Waste Chute B-529
Outside diameter 6 15/16" (175mm), inside diameter 5 1/2" (140mm), chute depth 5" (130mm). Rough Countertop Cutout: 5 5/8" diameter (140mm)....
-
GameTime ADA Wide Ramp Attachment 3D
Description Wide design allows children in mobility devices to pass by one another HDPE and punched steel design create a fun, 3-dimensional look Handrails provide...
-
11 [§ 4.7.6]
Built-up curb ramps should have flared sides with a slope of 10 percent or less or have edge protection and handrails on the sides....
-
11B-303.5 Warning curbs
A warning curb is not required when a guard or handrail is provided with a guide rail centered 2 inches (51 mm) minimum and 4 inches (102 mm) maximum above the surface of the walk or sidewalk...
-
Accessible Fishing Piers and Platforms
Sections 237 and 1005 of the 2010 Standards require at least twenty-five percent (25%) of railings, guards, or handrails (if provided) to be at a 34-inch maximum height (so that a person...
-
711.3.1 Through penetrations
and the fire-resistance- rated wall shall be permitted to be protected as follows: In concrete or masonry walls where the penetrating item is a maximum 6-inch (152 mm) nominal diameter...
-
11B-303.5 Warning curbs
A warning curb is not required when a guard or handrail is provided with a guide rail centered 2 inches (51 mm) minimum and 4 inches (102 mm) maximum above the surface of the walk or sidewalk...
-
1003.2.12.1 Height
Exception:For occupancies in Group R-3, and within individual dwelling units in occupancies in Group R-2, both as applicable in Section 101.2, guards whose top rail also serves as a handrail...
-
405.9 Edge Protection
Edge protection shall not be required on ramps that are not required to have handrails and have sides complying with 406.3. 2....
-
Accessible Routes Adjacent to the Playing Surface
The accessible route provisions in ADAAG address slope (maximum of 1:12 or 8.33%), width (minimum of 36 inches), cross slope (maximum of 1:50 or 2%), handrails, and changes in level....
-
405.9 Edge Protection
Edge protection shall not be required on ramps that are not required to have handrails and have sides complying with 406.3. 2....
-
1003.2.12.1 Height
Exception: For occupancies in Group R-3, and within individual dwelling units in occupancies in Group R-2, both as applicable in Section 101.2, guards whose top rail also serves as a handrail...
