In restaurants, cafeterias, banquet facilities, bars, and similar facilities, an accessible route shall be provided to all functional areas, including raised or sunken areas, and outdoor...
Search Results "Character Height (Raised)"
-
11B-206.2.5 Restaurants, cafeterias, banquet facilities and bars
-
703.4.1 Raised Letter and Braille Signage Height
-
H1
.), is a sign with raised characters and Braille mounted on the wall adjacent to the latch?...
-
1013.4 Raised character and braille exit signs
direct access to a stairway, an exterior area for assisted rescue, an exit stairway or ramp, an exit passageway, a horizontal exit and the exit discharge, a sign stating “EXIT” in visual characters...
-
904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
11B-904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
11B-904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
5.1.3 Transfer Surface Low Height Options for M301 and M302
5.1.3 Transfer Surface Low Height Options for M301 and M302 The Committee did not agree on a final low height recommendation....
-
504.2 Treads and Risers
All steps on a flight of stairs shall have uniform riser heights and uniform tread depths. Risers shall be 4 inches (100 mm) high minimum and 7 inches (180 mm) high maximum....
-
504.2 Treads and Risers
All steps on a flight of stairs shall have uniform riser heights and uniform tread depths. Risers shall be 4 inches (100 mm) high minimum and 7 inches (180 mm) high maximum....
-
504.2 Treads and Risers
All steps on a flight of stairs shall have uniform riser heights and uniform tread depths. Risers shall be 4 inches (100 mm) high minimum and 7 inches (180 mm) high maximum....
-
904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
Figure 505.4 Handrail Height – Drawing from the U.S. Access Board
-
11B-904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
11B-411.1.2 Car designations
Elevator cars shall be designated with a single alphabetic character....
-
1013.4 Raised character and braille exit signs
1013.4 Raised character and braille exit signs. [HCD 1-AC] Tactile exit signs shall be required at the following locations: 1....
-
5.1.2 Transfer Surface High Height Recommendations for M301 and M302
5.1.2 Transfer Surface High Height Recommendations for M301 and M302 The Committee recommends an adjustable height range with an upper height measuring at least 25 inches....
-
Transfer Protocols
Like protocol A her level height was recorded as her maximum height for this protocol....
-
5.1.1 Transfer Surface Height Adjustability Recommendation for M301 and M302
5.1.1 Transfer Surface Height Adjustability Recommendation for M301 and M302 The Committee recommends adjustable height in small, virtually continuous increments....
-
11B-406.1 General
Curb ramps, blended transitions and islands on accessible routes shall comply with Section 11B-406. Curb ramps may be perpendicular, parallel, or a combination of perpendicular and...
-
11B-406 CURB RAMPS, BLENDED TRANSITIONS AND ISLANDS
11B-406 Curb ramps, blended transitions and islands [2010 ADAS] 406 Curb Ramps ETA Editor's Note The differences between 2010 ADAS Section 406 and 2013 CBC Section...
-
407.3.1 Tactilely Discernible
Input controls shall be operable by touch and tactilely discernible without activation.
-
Islands [§406.7]
Islands [§406.7] A 48” min. long separation is necessary between curb ramps so that people using wheelchairs can clear one ramp before negotiating the next. Level cut-throughs...
