At least one accessible entrance that complies with 4.14 shall be protected from the weather by canopy or roof overhang....
Search Results "Edge Protection"
Filters
Commonly Searched Documents
-
6.2 Entrances
-
4.24.6 Exposed Pipes and Surfaces
Hot water and drain pipes exposed under sinks shall be insulated or otherwise configured so as to protect against contact. There shall be no sharp or abrasive surfaces under sinks....
-
11B-606.5 Exposed pipes and surfaces
Water supply and drain pipes under lavatories and sinks shall be insulated or otherwise configured to protect against contact....
-
BEA Inc. PBJ Series Jamb Style Push Plates (Push to Open)
Stainless steel materials are 100% recyclable and environmentally friendly Available in hard wired and wireless options (433, 390 or 300 MHz) Beveled edges...
-
American Specialties 9014 Surface Mounted Horizontal Baby Changing Station
Its two-part, vinyl-coated, adjustable safety strap assures child protection....
-
11B-303.2 Vertical
Changes in level of ¼ inch (6.4 mm) high maximum shall be permitted to be vertical and without edge treatment. [2010 ADAS] 303.2 Vertical. ...
-
810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
Question 12
., cantilevered display fixtures, trees in container pots, signs) with bottom edges that are between 27 and 80 inches above the walkway and extend more than 4 inches into the aisle?...
-
602.5 Spout Location
The spout shall be located 15 inches (380 mm) minimum from the vertical support and 5 inches (125 mm) maximum from the front edge of the unit, including bumpers....
-
R308.1.1.1 Dimensions
Boarding and alighting areas shall provide a clear length of 2.4 m (8.0 ft) minimum, measured perpendicular to the curb or street or highway edge, and a clear width of 1.5 m (5.0 ft) minimum...
-
407.8.3.1 Unobstructed Forward Reach
Where the operable part is located at the leading edge of the maximum protrusion within the length of the vertical reference plane of the ICT, the operable part shall be 48 inches (1220...
-
I. Required Survey Tools
following tools will be required to allow you to accurately complete the ADA Checklist for New Lodging Facilities: A. 12' Stiff Metal Tape Measure B. 24" Long Builders' Level (Square Edged...
-
602.5 Spout Location
The spout shall be located 15 inches (380 mm) minimum from the vertical support and 5 inches (125 mm) maximum from the front edge of the unit, including bumpers....
-
Clear Width [4.8.3]
The minimum dear width for ramps of 36 inches is measured between the leading edge of handrails. A maximum clear width is not specified....
-
Free-standing and Post-mounted Objects
Objects with leading edges at or below 27 inches or above 80 inches can protrude any amount....
-
2. Analysis of footrest clearance height and depth
Three dimensions were computed on the right-side for the sub-set of wheelchairs with footrests: Abdomen-Castor edge depth: measured as the horizontal distance from the abdomen to...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
Threshold Height
A maximum height of ½ inch is generally specified, although an exception permits a maximum height of ¾ inch at existing or altered thresholds that have a beveled edge on each side....
-
12209(b)(2)(A) Application
--The rights and protections under this Act shall, subject to subparagraph (B), apply with respect to any employee in an employment position in the House of Representatives and any employing...
-
12209(2) Establishment of remedies and procedures by instrumentalities
and procedures by instrumentalities The chief official of each instrumentality of the Congress shall establish remedies and procedures to be utilized with respect to the rights and protections...
-
§100.400(c)(4)
Intimidating or threatening any person because that person is engaging in activities designed to make other persons aware of, or encouraging such other persons to exercise, rights granted or protected...
-
Residential Facilities: ADA Standard Section 208.3.2
Section 208.3.2 covers scoping requirements in the current ADA Standards for the location of parking spaces in residential facilities.
-
1009.3.3 Area of Refuge
Areas of refuge are not required for smoke-protected or open-air assembly seating areas complying with Sections 1029.6.2 and 1029.6.3....
