(3) Grab bars. Structural reinforcement or other provisions that will allow installation of grab bars shall be provided in the locations shown in Fig. 49....
Search Results "L-Shaped Grab Bar"
Commonly Searched Documents
-
4.34.5.5(3) Grab bars
-
4.34.5.4(3) Grab bars
(3) Grab bars. Structural reinforcement or other provisions that will allow installation of grab bars shall be provided in the locations shown in Fig. 48....
- Access Board: Multi User Toilet Room Layout
-
Priority 3: Toilet Rooms
Word Fillable Form (2.4MB) Word Non-Fillable Form (2.2MB) PDF Non-Fillable Form (0.7MB)
-
Chapter 3: Study findings
[See subsections ...]
-
4.34.5.4 BATHTUBS
If a bathtub is provided, then it shall have the following features:
-
Plan 6A: 12-Foot Wide Accessible Guest Room
(section 607.2); • Recessed lavatory with vanity counter top permits shorter rear grab bar at water closet (section 604.5.2); • T-shaped turning space in room (section 603.2.1);...
-
Associated
Associated TAS 604.3.2 allows “associated” grab bars, dispensers, sanitary napkin disposal units, coat hooks, and shelves to overlap the required clearance around an accessible water...
-
Lateral grab bar use
The lateral grab bar was used least by subjects for the Adjustable gap protocol and most for the Side guard protocol....
-
609 Grab Bars
Section 609 covers grab bars at water closets, bathtubs, and showers. Specifications address size, spacing, position, surfaces, fittings, and structural strength....
-
§100.205(c)(3)
(3) All premises within covered multifamily dwelling units contain the following features of adaptable design:
-
Attachment J
Provide and maintain a side grab bar that has at least 1½ inches between the grab bar and any other object, such as the toilet paper dispenser. ...
- Thinking Out of the Box Engineering Applications (TOBEA)
-
11B-404.2.9 Door and gate opening force
Powered doors shall be controlled on both the interior and exterior sides of the doors by sensing devices, push plates, vertical actuation bars or other similar operating devices complying...
-
1018.8 Resting Intervals
Resting intervals shall comply with 1018.8.
-
F248.1.2 Beach Nourishment
Beach access routes shall be provided in a number complying with F248.2 where the entity that administers or manages a beach undertakes a beach nourishment project. EXCEPTION: The...
-
1018.8.1 Size
Resting intervals shall be 60 inches minimum (1525 mm) by 60 inches (1525 mm) minimum.
-
F248.1 General
Beach access routes complying with 1018 shall be provided in accordance with F248.1. Beach access routes shall be permanent or removable. EXCEPTION: Beach access routes shall not...
-
Cross Slope [1018.7.2]
When beach access routes are constructed of asphalt, concrete, or boards, the cross slope must be no steeper than 1:48 (2 percent). When beach access routes are constructed of...
-
Exemptions for an Entire Trail or Beach Access Route [1017.1, Exception 2 and 1018.1, Exception 2]
When extreme or numerous conditions for exceptions make it impractical to construct a trail or beach access route that complies with the technical requirements, the ABA Standards...
-
Documenting Use of the Conditions for Exceptions on a Portion of a Trail or Beach Access Route [F204.4.1]
When using the conditions for exceptions on a portion of trail or a beach access route, Federal agencies should document in writing why they could not fully comply with a...
-
Getting to the Water—Beach Access Routes
Beach access routes allow pedestrians to get across the beach so they can play, swim, or participate in other beachrelated [sic] activities. A beach access route is a continuous...
-
Tread Obstacles on Beach Access Routes
Tread obstacles on a beach access route must not be more than 1 inch (25 millimeters) high. When the surface of the beach access route is paved or is built with boards, tread...
-
Protruding Objects on Beach Access Routes
Outdoor accessibility guidelines define protruding objects as constructed features such as signs that extend into the clear width area of a beach access route or resting interval and...