Grab bars are designed to support a load of at least 250 pounds (113.4 kilogram) grab bars at 33 inch (83.82 cm) above floor or in accordance with local accessibilty regulations....
Search Results "Extended Floor Surface"
Filters
Commonly Searched Documents
-
Murdock Manufacturing Grab Bars
-
AD Systems’ Exam Room Doors
Compared to swing-design doors, our exam room doors can save up to 25-30 square feet of usable floor space for each application....
-
Rebuilding Together Kent County - Chestertown, MD
Our volunteers have donated over 7000 hours, with a market value of more than $170,000, to demolish and rebuild a kitchen addition; reconstruct a front porch; repair plumbing, floors, roofs...
-
Stanley FBB 266 Heavy Weight Ball Bearing “Swing Clear” Offset Door Hinge
clear 90° Equipped with four Stanley permanently lubricated non-detachable ball bearings Pins in nonferrous hinges are stainless steel Heavy weight gauges increase available bearing surface...
-
Stanley FBB 268 Heavy Weight Ball Bearing “Swing Clear” Offset Door Hinge
clear 90° Equipped with four Stanley permanently lubricated non-detachable ball bearings Pins in nonferrous hinges are stainless steel Heavy weight gauges increase available bearing surface...
-
Stanley FBB 264 Heavy Weight Ball Bearing “Swing Clear” Offset Door Hinge
clear 90° Equipped with four Stanley permanently lubricated non-detachable ball bearings Pins in nonferrous hinges are stainless steel Heavy weight gauges increase available bearing surface...
-
Stanley FBB 269 Heavy Weight Ball Bearing “Swing Clear” Offset Door Hinge
clear 90° Equipped with four Stanley permanently lubricated non-detachable ball bearings Pins in nonferrous hinges are stainless steel Heavy weight gauges increase available bearing surface...
-
Physical Accessibility
For example, if stairs lead to the upper floors of a school and the school does not have an elevator, ramp, or chair lift, and a student with a disability is unable to traverse the stairs...
-
Section 4.1.3, Accessible Buildings: New Construction (Preamble, Section-by-Section Analysis)
Sections 4.1.3 (1) through (4) cover accessible routes, protruding objects, ground and floor surfaces, and stairs....
-
804 Kitchens and Kitchenettes
For example, requirements for clearances in pass through and U-shaped kitchens apply only to kitchens with cook tops or conventional ranges (804.2), and specified kitchen work surfaces are...
-
Section 4.1.3, Accessible Buildings: New Construction (Section-By-Section Analysis and Response to Comments)
Sections 4.1.3 (1) through (4) cover accessible routes, protruding objects, ground and floor surfaces, and stairs....
-
Mounting Height and Location
As a result, the height of braille and raised characters are held to the same range: 48 to 60 inches above the floor or ground (703.4.1)....
-
III-7.5170 Telephones
telephones and need "text telephones" (referred to in the Department's rule as telecommunication devices for the deaf (TDD's)): 1) One accessible public phone must be provided for each floor...
-
11B-604.8.1.1 Size
shall be 60 inches (1524 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1422 mm) deep minimum for wall hung water closets and 59 inches (1499 mm) deep minimum for floor...
-
BHMA
Builders Hardware Manufacturers’ Association 355 Lexington Avenue, 15th Floor New York, NY 10017-6603 A 156.10-2011: Power Operated Pedestrian Doors 1010.1.4.2, 11B-404.2.9,...
-
11B-608.5.3 Alternate roll-in type shower compartments
The controls, faucets, and shower spray units shall be located above the grab bar, but no higher than 48 inches (1219 mm) above the shower floor....
-
Cybex Total Access Recumbent Bike
This allows fitness enthusiasts who have physical or sensory limitations to take advantage of fitness training on the same gym floor and using the same equipment as those who do not....
-
What Terminology Should Be Used?
Disability Etiquette Use common sense and extend common courtesy to everyone. Don't patronize anyone; treat adults like adults. Be patient....
-
4.3.6 Reach Limits
mobility users with functional reaching ability that might be expected to reach (without a weight) to a 100 mm x 100 mm (3.9 in. x 3.9 in.) target location in space at a given height from the floor...
-
Minimum Rear Wall Required.
Using the 2010 ADA Standards for Accessible Design, the minimum bench length would be 42" and the width of the clear floor space adjacent to the end of the bench would be 30"....
-
Existing elevator cab size
Requires the Accessibility Specialist plan or above. (Login or upgrade your account!)
-
Question: Alteration vs. Maintenance for Stairs in Pre-ADA Building
The site in question is a large, pre-ADA building with retail on the ground floor and offices (not public accomodations) on the second floor....
-
3.13(c) Companion Seating
Wheelchair spaces and companion seats shall be located on the same floor level as other seats in the same row — they shall not be higher or lower relative to the other seats in the row or...
-
5.8.3 Breast Platform Recommendations
The height of the breast platform shall be 30 inches high minimum and 42 inches high maximum above the floor when in use by a patient seated in a wheelchair...
