This provides flexibility for new technologies and innovative designs solutions that may not have been taken into account when ADAAG was developed....
Search Results "Floor Designation"
Commonly Searched Documents
-
Equivalent Facilitation [2.2]
-
Definitions
“Accessible on Election Day” means that a polling place is compliant with the 2010 ADA Standards for Accessible Design (“2010 Standards”) on Election Day, whether such compliance is...
-
Rotational Penetrometer
The Rotational Penetrometer, developed by Beneficial Designs, uses a wheelchair caster placed on a spring loaded caliber in a metal tripod frame which suspends the caster about 6 inches...
-
On-Site Readers
If this happens, designate people to serve as on-site readers....
-
Three Additional Features for Van-Accessible Parking Spaces
(plan drawing showing a van-accessible parking space with a 96 inch wide designated parking space, a 96 inch wide min. marked access aisle and the following notes) Sign with...
-
Accessible Parking Spaces
When a business restripes a parking lot, it must provide accessible parking spaces as required by the ADA Standards for Accessible Design....
-
Research Projects
The Board’s research program is focused on the study of accessibility relating to architecture and design, communication, and transportation....
-
1607A.8.2 Grab bars, shower seats and dressing room bench seats
Grab bars, shower seats and dressing room bench seat systems shall be designed to resist a single concentrated load of 250 pounds (1.11 kN) applied in any direction at any point on the grab...
-
11B-803.1 General
Partitions and doors should be designed to ensure people using accessible dressing and fitting rooms privacy equivalent to that afforded other users of the facility....
-
11B-803.1 General
Partitions and doors should be designed to ensure people using accessible dressing and fitting rooms privacy equivalent to that afforded other users of the facility....
-
1010.1.9.1 Hardware
These design requirements for door handles, pulls, latches, locks and other operating devices, intended for use on required means of egress doors in other than Group R and M occupancies...
-
11B-224.8.2 More than 50-bed facilities
In sleeping rooms with more than 25 beds covered by this part, a minimum of 5% of the beds shall have clear floor space complying with section 806.2.3 of the 2010 Standards....
-
11B-205.1 General
Floor electrical receptacles shall not be required to comply with Section 11B-309. 5. HVAC diffusers shall not be required to comply with Section 11B-309. 6....
-
II. Terms of Agreement
The XL Center Parties further agree that modifications to the XL Center must comply with the 2010 ADA Standards for Accessible Design (the 2010 Standards), See 28 CFR § 36.104 (defining...
-
2.5 Physical Accessibility.
The design and construction of new buildings and the alterations and the necessary structural modifications to existing buildings must comply with accessibility standards under Title II...
-
Jean Tessmer
I have specified and had this particular pocket door privacy latchset installed in new construction where I did not have enough door clear floor space for a swing door....
-
19 Inch Low Height
The height of the lift seat shall be designed to allow a stop at 16 inches (405 mm) minimum to 19 inches (485 mm) maximum measured from the deck to the top of the seat surface when in the...
-
11B-206.2.1 Site arrival points
Department of Transportation and most State departments of transportation are revising their design standards and regulations for the public right of way based on recent research and guidelines...
- CS SofStop Pocket Door Kit
- Savaria ORION Limited Use/Limited Application Elevator Video
- Patriot Portable Lift by Aqua Creek Products
-
Restaurants and Cafeterias: ADA Standard Section 206.2.5
Section 206.2.5 covers scoping requirements in the most current ADA Standards for accessible routes in restaurants and cafeterias
-
General Holding Cells and General Housing Cells: ADA Standard Section 232.2
Section 232.2 covers scoping requirements in the current ADA Standards for general holding cells and general housing cells.