Parking facilities with valet parking must provide accessible parking spaces to allow self-parking by people with disabilities (and must also provide an accessible passenger loading zone...
Search Results "Vertical Access"
-
Are accessible parking spaces required on a site where valet service is provided but vehicles are parked off site, such as in a public parking garage or on public streets?
-
11B-805 Medical care and long-term care facilities
Built-in cabinets, counters and work surfaces shall be accessible, including: patient wardrobes, nurses’ stations, administrative centers, reception desks, medicine preparation areas, laboratory...
-
G.7.ii. - Are there any circumstances under which Federal EIT must be retrofitted with EIT that meets the access board's standards?
Section 508(a) generally requires that agencies ensure that the EIT they develop, procure, maintain, or use meets the Access Board's standards....
-
407.8 Reach Height and Depth
At least one of each type of operable part of stationary ICT shall be at a height conforming to 407.8.2 or 407.8.3 according to its position established by the vertical reference plane specified...
-
704.5 TTY Shelf
The shelf shall be capable of accommodating a TTY and shall have 6 inches (150 mm) minimum vertical clearance above the area where the TTY is to be placed....
-
11B-703.2.5 Character height
Character height measured vertically from the baseline of the character shall be 5/8 inch (15.9 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”....
-
E.5. - Will agencies have a way of obtaining standardized product testing results to determine if EIT meets the Access Board’s technical provisions?
In May 2001, the agencies with lead responsibilities for the implementation of Section 508 convened an Accessibility Forum to facilitate discussion among the EIT industry, disability advocacy...
-
G.1. - Are there any exceptions to the requirement to acquire EIT that meets the technical provisions of the Access Board's standards?
Agencies are not required to acquire EIT that meets the technical provisions of the Access Board's standards if the acquisition: is for a national security system (FAR 39.204(b)...
- DOT: Traveling with Service Animals with Closed Captioning
- NYC Board of Elections: Video 5 - Verifying Voting Equipment Setup
-
Can a single EV charger service two EV Accessible spots or does each spot have to have its own charger?
RESPONSE: A single multiport EV charger that can simultaneously charge two vehicles can be used to serve two EV spaces required to be accessible....
-
D.2. - Must requiring officials consider all the Access Board’s technical provisions and functional performance criteria each time they purchase EIT?
Requiring officials need only consider all applicable technical provisions from the Access Board’s standards to ensure acquired products provide comparable access (see section B.2.ii, above...
-
R408.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
1) Where the Standard specifically refers to 303
1) Where the Standard specifically refers to 303, such as 403.4 changes in level for walking surfaces: Here it is clear that changes in level that comply with either the ¼" maximum vertical...
-
Edge Protection [§405.9]
Edge protection is not required at: ramps no higher than 6” that have side flares ramp landings serving an adjoining run or stairway sides of ramp landings with vertical...
-
11B-704.5 TTY shelf
The shelf shall be capable of accommodating a TTY and shall have 6 inches (152 mm) minimum vertical clearance above the area where the TTY is to be placed....
-
§ 38.159(b)(10) Platform movement
The maximum platform horizontal and vertical acceleration when occupied shall be 0.3g....
-
404.2.10 Door and Gate Surfaces
Swinging door and gate surfaces within 10 inches (255 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
404.2.10 Door and Gate Surfaces
Swinging door and gate surfaces within 10 inches (255 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
Sight Lines
Sight Lines Both the horizontal and vertical viewing angles must be considered in the design of assembly areas....
-
18. Where an existing ground level play component is replaced, should the new component comply with the technical provisions of Section 1008.4 even if there is not an accessible route to it?
Unless the required number of accessible ground level play components are provided, the new play component would be required to be accessible....
- Wireless RERC: Accessibility, Usability, and the Design of Wearables and Wirelessly Connected Devices
-
11B-504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
11B-504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
