Accessible routes serving holes on miniature golf courses shall comply with Chapter 4....
Search Results "Golf Club Reach Range"
Commonly Searched Documents
-
1007.2 Accessible Routes
-
1007.2 Accessible Routes
Accessible routes serving holes on miniature golf courses shall comply with Chapter 4....
-
1007.2 Accessible Routes
Accessible routes serving holes on miniature golf courses shall comply with Chapter 4....
-
11B-1007.2 Accessible routes
Accessible routes serving holes on miniature golf courses shall comply with Division 4....
-
11B-1007.2 Accessible routes
Accessible routes serving holes on miniature golf courses shall comply with Division 4....
-
11B-1007.2 Accessible routes
Accessible routes serving holes on miniature golf courses shall comply with Division 4....
-
Reach Range
Accessible reach ranges specify a minimum height of 15 inches (308.3) for unobstructed reaches....
- Magnuson Group RIGA Series Waste Receptacle
-
11B-104.1.1 Construction and manufacturing tolerances
Where the requirement states a specified range, such as in 609.4 where grab bars must be installed between 33 inches and 36 inches above the floor, the range provides an adequate tolerance...
-
11B-104.1.1 Construction and manufacturing tolerances
Where the requirement states a specified range, such as in 609.4 where grab bars must be installed between 33 inches and 36 inches above the floor, the range provides an adequate tolerance...
-
11B-104.1.1 Construction and manufacturing tolerances
Where the requirement states a specified range, such as in Section 11B-609.4 where grab bars must be installed between 33 inches and 36 inches above the floor, the range provides an adequate...
-
F104.1.1 Construction and Manufacturing Tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
Water Hydrants
Standard handpumps require a force greater than 5 pounds (2.2 newtons) and a long reach to operate....
-
104.1.1 Construction and Manufacturing Tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
104.1.1 Construction and Manufacturing Tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
- Landscape Forms Inc. Select Modular Steel Recycling Units
- Magnuson Group UMEA Waste Receptacles
- Landscape Forms Inc. Sort Recycling Units
-
K5
K5. If the operating controls are set back 10 to 24 inches from the front edge of the counter or table are they no higher than 46 inches above the floor? [ADA Standards §...
-
§301(7)(L)
A gymnasium, health spa, bowling alley, golf course, or other place of exercise or recreation....
-
Clear Floor Space [§309.2]
This facilitates access since the forward reach does not extend beyond a wheelchair user’s toes....
- Filter Pave™ Porous Paving for Stormwater Management
- Pilot Rock Smoker's Cease Fire Ash Receptacle