(2) Once the charging party or plaintiff satisfies the burden of proof set forth in paragraph (c)(1) of this section, the respondent or defendant has the burden of proving that the challenged...
Search Results "9-1-1 Service"
-
§100.500(c)(2)
-
4.5.6 Openings
Openings in the clear floor or ground space surface shall not allow passage of a sphere more than 1/2 inch (13 mm) diameter....
-
4.6.7 Openings
Openings in the clear floor or ground space surface shall not allow passage of a sphere more than 1/2 inch (13 mm) diameter....
-
11B-406.5.8 Counter slope
Counter slopes of adjoining gutters and road surfaces immediately adjacent to and within 24 inches (610 mm) of the curb ramp shall not be steeper than 1:20....
-
§ 37.3 Public entity
Public entity means: (1) Any state or local government; (2) Any department, agency, special purpose district, or other instrumentality of one or more state or local governments; and...
-
1009.4.1 Standby power
The elevator shall meet the emergency operation and signaling device requirements of California Code of Regulations, Title 8, Division 1, Chapter 4, Subchapter 6, Elevator Safety Orders....
- Eliason Corporation RMR-1500 Traffic Door (Chase Doors - Durulite Retailer Door)
-
Reasonable Accommodation
The employee proposes that he use a TTY(11) to call a relay service operator who can then place the telephone call and relay the conversation between the parties....
- Disability Network Oakland & Macomb (DNOM) - Clinton Township and Southfield, MI
-
306.3.1 General
Space under an element between 9 inches (230 mm) and 27 inches (685 mm) above the finish floor or ground shall be considered knee clearance and shall comply with 306.3....
-
References
Disability and Rehabilitation: Assistive Technology 7(1); 20-9, 2012. Nyland J, Quigley P, Huang C, Lloyd J, Harrow J and Nelson A....
-
Statutory Background
The standard-setting agencies are the Department of Defense (DOD), the General Services Administration (GSA), the Department of Housing and Urban Development (HUD), and the U.S....
-
8. May a public school require an individual with a hearing, vision, or speech disability to bring another person to interpret or facilitate communication, or to rely on a person who accompanies an individual with such a disability?
a public school from requiring an individual with a disability to bring another person to interpret for him or her.35 Assuming the provision of an interpreter or other auxiliary aid or service...
-
232.2.1 Cells with Mobility Features
Exception: 1....
-
Literature Cited
Department of Agriculture, Forest Service, Forest Products Laboratory. 10 p. Laufenberg T.; Krzysik, A.M.; Winandy, J.E. 2003....
-
Recreation Opportunity Spectrum and Recreation Site Scale
Definitions of each level of the Forest Service's recreation site scale are included in the Forest Service Manual, Chapter 2330, exhibit 01....
-
[2010 ADAS] 105.2.5 NFPA
A fire extinguisher monitoring device shall indicate those conditions for a specific fire extinguisher required by California Code of Regulations, Title 19, Division 1, Chapter 1, Section...
-
11B-406.3.2 Turning space
The slope of the turning space in all directions shall be 1:48 maximum. FIGURE 11B-406.3.2 ‡‡ PARALLEL CURB RAMPS...
-
Commerce
Commerce means travel, trade, traffic, commerce, transportation, or communication— (1) Among the several States; (2) Between any foreign country or any territory or possession and...
-
§382.57(c)(7)(ii) Characters
Characters must contrast with their background with a minimum luminosity contrast ratio of 3:1....
-
Commerce
Commerce means travel, trade, traffic, commerce, transportation, or communication -- (1) Among the several States; (2) Between any foreign country or any territory or possession and...
-
12201(c)(3)
Paragraphs (1), (2), and (3) shall not be used as a subterfuge to evade the purposes of title I and III....
-
503.4 Floor and Ground Surfaces
EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
R409.7 Cross Section
Where expansion joints are necessary for large spans of handrails, the expansion joint is permitted to be smaller than the specified cross section diameters for a 25mm (1 in) length....