The intersection of two outdoor recreation access routes providing a T-shaped space complying with ABAAS section 304.3.2 where the base and the arms of the T-shaped space extend 48 inches...
Search Results "Military Base"
Filters
Commonly Searched Documents
-
2.6.1.2
-
11B-1009.5.2 Transfer space
A transfer space of 60 inches (1524 mm) minimum by 60 inches (1524 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer platform surface and shall...
-
§ 37.135(d) Phase-in of implementation
Each plan shall provide full compliance by no later than January 26, 1997, unless the entity has received a waiver based on undue financial burden....
-
11B-1009.5.2 Transfer space
A transfer space of 60 inches (1524 mm) minimum by 60 inches (1524 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer platform surface and shall...
-
Spectrum Aquatics Gallatin Water Powered Assisted Access Lift
surface for safety and comfort Footrest will not disintegrate or flake over time Swing out footrest allows for ease of transfer Pinchless flip up outer arm Base...
-
M302.4 Lift Compatibility (Section-by-Section Analysis)
The MDE NPRM proposed to require that diagnostic equipment used by patients in the seated position be usable with a patient lift and comply with either the proposed clearance in base (proposed...
-
704.3 Volume Control Telephones
Amplifiers on pay phones are located in the base or the handset or are built into the telephone. Most are operated by pressing a button or key....
-
Technical Memorandum TM 2014-24 Location (Accessible Routes)
Although the term "same area" is not defined in TAS, it shall mean "not in a different section of space within a building" based on TAS 106.3 and the definitions from collegiate dictionaries...
-
Technical Memorandum TM 2013-12 Number of Accessible Elements and Spaces
For example, health care providers are subject to compliance with TAS based on Chapter 469.003(a)(4) and Rule 68.20(c)(6) and since there are no exemptions or scoping limits for examination...
-
Notes
In mammography, the presence of the base support for the physical stability and operation of the equipment falls into this category....
-
Height
The maximum height in ADAAG was used because there was no other objective information available upon which to base a decision on effective height for assisted transfers....
-
Forms + Surfaces Summit Bike Rack
Bodies of stainless steel tubing Surface mount option has a cast aluminum base that conceals a ¼" stainless steel mounting plate Bodies have a Satin finish; base castings have a durable...
-
Lang Equipment Co. Heavy Duty Throw Latch & Keeper for Bathroom Stall Door
Throw and Keeper Bases: 2" high x 2" wide x 3/16" thick, with four screw holes each. Reach: 5-7/16" from edge of base to end of throw. Throw is 1-1/4" wide x 7/32" thick....
-
804.2.1 Pass Through Kitchen
through kitchens where counters, appliances or cabinets are on two opposing sides, or where counters, appliances or cabinets are opposite a parallel wall, clearance between all opposing base...
-
STEP 2 Determine what is needed
Table 240.2.1.2 establishes a minimum level of ground level play components required to be on an accessible route, based on the number of elevated play components provided....
-
Recommendations
Recommendations Based on the data in Table 1 and the observations above, we recommend: a minimum flat surface of 40 in. length for platforms accommodating wheeled mobility devices...
-
5.8.2 Knee and Toe Clearance Under Breast Platform
proposed 25 inch absolute dimension; increasing the knee clearance directly underneath the breast platform to a minimum of 18 inches; and assuring unobstructed floor space in front of the base...
-
12113(c) Qualification standards and tests related to uncorrected vision
.— Notwithstanding section 12102(4)(E)(ii), a covered entity shall not use qualification standards, employment tests, or other selection criteria based on an individual’s uncorrected vision...
-
407.12.1.2 Vertical Plane for Forward Reach (Section-by-Section Analysis)
The 30-inch dimension is based on the width of a stationary occupied wheelchair....
-
Sec.36.208(c)
(c) In determining whether an individual poses a direct threat to the health or safety of others, a public accommodation must make an individualized assessment, based on reasonable judgment...
-
4.31.2 Clear Floor or Ground Space
Bases, enclosures, and fixed seats shall not impede approaches to telephones by people who use wheelchairs....
-
703.2.5 Character Height
Character height measured vertically from the baseline of the character shall be 5/8 inch (16 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter "I"....
-
A4.30.2 Character Proportion
The size of characters must be based upon the intended viewing distance....
-
Alterations / Additions
Alterations / Additions The minimum number of accessible patient rooms required is based on the total number of bedrooms that are altered or added, including where a unit or department...
