This information enables individuals with disabilities to decide whether to hike the trail based on the characteristics of the trail....
Search Results "Military Base"
Filters
Commonly Searched Documents
-
1017.10 Trailhead Signs
-
III-4.1200 Safety
However, the public accommodation must ensure that its safety requirements are based on real risks, not on speculation, stereotypes, or generalizations about individuals with disabilities...
-
1. Public Participation and Request for Comments
The Access Board will consider all the comments and may change the proposed standards based on the comments....
-
§ 37.139(i)
(i) A request for a waiver based on undue financial burden, if applicable....
-
§ 38.125(c)(1) Design load
or longer shall support a load of 600 pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches by 26 inches, with a safety factor of at least 3 based...
-
§ 38.95(c)(1) Design load
or longer shall support a load of 600 pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches by 26 inches, with a safety factor of at least 3 based...
-
11B-703.2.5 Character height
Character height measured vertically from the baseline of the character shall be 5/8 inch (15.9 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”....
-
Hager Companies Door Pull 974B
Door Pull Pull Material:- Brass, bronze, stainless steel Base Material:- Black anodized aluminum ...
-
Stabilizer
The Stabilizer is applied to a base of 3 inches of compacted native soils. Stabilizer arrives pre-mixed with ¼ inch minus aggregate and is applied at a 3-inch depth on top of the base....
-
704.3 Volume Control Telephones
Amplifiers on pay phones are located in the base or the handset or are built into the telephone. Most are operated by pressing a button or key....
-
17. May an employer apply a "no-fault" leave policy, under which employees are automatically terminated after they have been on leave for a certain period of time, to an employee with a disability who needs leave beyond the set period?
While undue hardship cannot be based solely on the existence of a no-fault leave policy, the employer may be able to show undue hardship based on an individualized assessment showing the...
-
704.3 Volume Control Telephones
Amplifiers on pay phones are located in the base or the handset or are built into the telephone. Most are operated by pressing a button or key....
-
501.1 Scope
Firmware is read-only memory (ROM) based software that is sometimes distinguished from software and hardware....
-
Managed Use
A mode of travel that is actively managed and appropriate on a trail, based on its design and management. 1....
-
Category 1 Eligibility
One implication of this language is that an individual does not lose paratransit eligibility based on “inability to navigate the system” because the individual chooses to travel with a friend...
-
1009.5.2 Transfer Space
A transfer space of 60 inches (1525 mm) minimum by 60 inches (1525 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer platform surface and shall...
-
804.2.1 Pass Through Kitchen
through kitchens where counters, appliances or cabinets are on two opposing sides, or where counters, appliances or cabinets are opposite a parallel wall, clearance between all opposing base...
-
804.2 Clearance
Clearances are measured from the furthest projecting face of all opposing base cabinets, counter tops, appliances, or walls, excluding hardware....
-
Are charging parties protected from retaliation?
Even if an individual has already filed a charge of discrimination, s/he can file a new charge based on retaliation....
-
219 Assistive Listening Systems
Section 219.3 specifies the minimum number of receivers according to a sliding scale based on the seating capacity of the assembly area....
-
1009.4.1 Clear Deck Space
A clear deck space of 60 inches (1525 mm) minimum by 60 inches (1525 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer wall....
-
804.2 Clearance
Clearances are measured from the furthest projecting face of all opposing base cabinets, counter tops, appliances, or walls, excluding hardware....
-
Water Hydrants
The surface at the base of water hydrants at recreation areas must be firm and stable with a 60-inch turning radius. See the "Surfaces" rule of thumb above....
-
§ 36.208(b)
(b) In determining whether an individual poses a direct threat to the health or safety of others, a public accommodation must make an individualized assessment, based on reasonable judgment...
