., grab bars, enlarged toilet stalls, accessible faucet controls);...
Search Results "Grab Bar Clearance"
Filters
Commonly Searched Documents
-
§ 37.43(e)(2)(ii)
-
1134A.7, Item 1
Water closets shall be located within bathrooms in a manner that permits a grab bar to be installed on at least one side of the fixture....
-
11B-604 Water closets and toilet compartments
SECTION 11B-604 Water closets and toilet compartments 11B-604.5 Grab bars. 11B-604.5.2 Rear Wall....
-
Clear Floor Space: ADA Standard Section 606.2
Section 606.2 covers the current ADA Standards for clear floor space at lavatories and sinks.
-
Figure 608.3.2 Grab Bars for Standard Roll-In Type Showers – Drawing from the U.S. Access Board
-
11B-411.4.3 Platform to hoistway clearance
Platform to hoistway clearance shall comply with Section 11B-407.4.3....
-
4.26.3(4)
(4) Tensile force induced in a fastener by a direct tension force of 250 lbf (1112N) plus the maximum moment from the application of 250 lbf (1112N) shall be less than the allowable...
-
4.26.3(3)
(3) Shear force induced in a fastener or mounting device from the application of 250 lbf (1112N) shall be less than the allowable lateral load of either the fastener or mounting...
-
Is latch-side maneuvering clearance as specified in the Standards applicable to doors with panic bars?
When latch-side clearance is required as part of the maneuvering clearances specified for a door, including on the push side of doors with a forward approach that have both a closer and...
-
11B-806.2.5 Kitchens, kitchenettes and wet bars
11B-806.2.5 Kitchens, kitchenettes and wet bars. Kitchens, kitchenettes and wet bars shall comply with Section 11B-804. [2010 ADA Standards] 806.2.5 Kitchens and Kitchenettes....
-
4.23.4 Water Closets
4.17; where 6 or more stalls are provided, in addition to the stall complying with 4.17.3, at least one stall 36 in (915 mm) wide with an outward swinging, self-closing door and parallel grab...
-
11B-306.3.4 Clearance reduction
Between 9 inches (229 mm) and 27 inches (686 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches...
-
806.4 Hotel, Motel and Condominium Special Accessibility Features
percent of the guest rooms minus the Total Number of Required (accessible) Rooms required by Table 224.2 shall provide the following additional special accessibility features: (i) Grab...
-
306.2.4 Additional Clearance
Space extending greater than 6 inches (150 mm) beyond the available knee clearance at 9 inches (230 mm) above the finish floor or ground shall not be considered toe clearance....
-
11B-809.10.8.4 Knee and toe clearance
Knee and toe clearance shall be provided and comply with Section 11B-306....
-
WET BAR
WET BAR. [DSA-AC] An area or space with a counter equipped with a sink and running water but without cooking facilities....
-
Figure 608.3.3 Grab Bars for Alternate Roll-In Type Showers – Drawing from the U.S. Access Board
-
Doorways: ADA Standard Section 405.7.5
Section 405.7.5 covers the current ADA Standards for doorway maneuvering clearance at ramp landings.
-
11B-306.3.5 Width
Knee clearance shall be 30 inches (762 mm) wide minimum....
-
11B-306.2.5 Width
Toe clearance shall be 30 inches (762 mm) wide minimum....
-
4.3.4 Knee and Toe Clearances
from wall • Toe clearance height: 356 mm (14 in.) minimum , measured from the floor • Knee clearance height: 711 mm (28 in.) minimum, measured from the floor • Knee clearance depth...
-
7(2) Usable bathrooms
Powder rooms that are subject to the requirements of section 100.205(c)(3)(iv) must have reinforcements for grab bars as provided in the guideline for Requirement 6....
-
11B-306.3.2 Maximum depth
Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (229 mm) above the finish floor or ground....
-
11B-407.4.3 Platform to hoistway clearance
The clearance between the car platform sill and the edge of any hoistway landing shall be 1¼ inch (32 mm) maximum....
