Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
Search Results "Shower Slope"
-
608.2.3 Alternate Roll-In Type Shower Compartments
-
2a
Do large showers measure at least 30" wide by 60" deep as shown in Figure 35(b) below?...
-
608 Shower Compartments
[See subsections ...]
-
ROLL-IN SHOWER STALLS
[See subsections ...]
-
4.21 Shower Stalls
[See subsections ...]
-
A4.21 Shower Stalls
[See subsections ...]
-
608 Shower Compartments
[See subsections ...]
-
A4.21 SHOWER STALLS
[See subsections ...]
-
608 Shower Compartments
[See subsections ...]
-
608.5 Controls
Controls, faucets, and shower spray units shall comply with 309.4....
-
608.5 Controls
Controls, faucets, and shower spray units shall comply with 309.4....
-
1a
Do all small showers, if provided in accessible guestroom/suites, measure exactly 36" wide by 36" deep as shown in Figure 35(a) below: [ADA Stds. 4.21.2] Yes __ No __ N/A __ Comments:...
-
Cross Slope [1018.7.2]
When beach access routes are constructed of asphalt, concrete, or boards, the cross slope must be no steeper than 1:48 (2 percent)....
-
4.21.4 Grab Bars
Grab bars complying with 4.26 shall be provided as shown in Fig. 37.
-
9. Faucet Controls
Do roll-in showers have faucet controls that are easily operable with one hand (i.e.: levers, wrist blades, single arm, etc.) without tight grasping, pinching or twisting of the wrist?...
-
4.23 Bathrooms, Bathing Facilities, and Shower Rooms
[See subsections ...]
-
A4.23 Bathrooms, Bathing Facilities, and Shower Rooms
[See subsections ...]
-
A4.23 BATHROOMS, BATHING FACILITIES, AND SHOWER ROOMS
[See subsections ...]
-
4.23 BATHROOMS, BATHING FACILITIES, AND SHOWER ROOMS
[See subsections ...]
-
1e
Do all small showers have faucet controls that are easily operable with one hand (i.e.: levers, wrist blades, single arm, etc.) without tight grasping, pinching or twisting of the wrist?...
-
T402.8 Running Slope
The maximum running slope of ramps and bridgeplates shall comply with T402.8.1 or T402.8.2....
-
11B-406.2.1 Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
11B-406.2.1 Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
11B-406.2.1 Slope
Ramp runs shall have a running slope not steeper than 1:12....