The guidelines require tubs to have shower spray units that can be used as both a fixed position shower head and a hand-held shower (607.6)....
Search Results "Shower Slope"
Commonly Searched Documents
- 
    
  
  Shower Spray Unit
  
- 
    
  
  T402.8 Running Slope
  The maximum running slope of ramps and bridgeplates shall comply with T402.8.1 or T402.8.2.... 
- 
    
  
  11B-406.2.1 Slope
  Ramp runs shall have a running slope not steeper than 1:12.... 
- 
    
  
  11B-406.2.1 Slope
  Ramp runs shall have a running slope not steeper than 1:12.... 
- 
    
  
  11B-406.2.1 Slope
  Ramp runs shall have a running slope not steeper than 1:12.... 
- 
    
  
  Verify Rough Plumbing
  from side walls. 11B-606.6 Location of bathtub controls and drain. 11B-607.5 Installation height and location of shower... 
- 
    
  
  Verify Rough Plumbing
  from side walls. 11B-606.6 Location of bathtub controls and drain. 11B-607.5 Installation height and location of shower... 
- 
    
  
  Size and Clearances [4.21.2]
  Recommendation:Placing them beyond this space however can provide easier maneuvering to and from the shower. When a seat is provided in a roll-in shower, it must be a folding seat.... 
- 
    
  
  Transfer Compartments
  Seats are required in transfer compartments and roll-in showers in transient lodging guest rooms (608.4).... 
- 
    
  
  11B-607.6 Shower spray unit and water
  11B-607.6 Shower spray unit and water.... 
- 
    
  
  Surface, Slope, and Openings [1011.2.2, 1011.2.3, and 1011.2.4]
  When the surface of the clear ground space is constructed of concrete, asphalt, or boards, the slope of the clear ground space must be no steeper than 1:48 (2 percent) in any direction.... 
- 
    
  
  11B-607.6 Shower spray unit and water
  A shower spray unit with a hose 59 inches (1499 mm) long minimum that can be used both as a fixed-position shower head and as a hand-held shower shall be provided.... 
- 
    
  
  11B-607.6 Shower spray unit and water
  A shower spray unit with a hose 59 inches (1499 mm) long minimum that can be used both as a fixed-position shower head and as a hand-held shower shall be provided.... 
- 
    
  
  5. Grab Bar
  Is there a horizontal grab bar on the wall alongside the shower seat (but not behind the shower seat) for stabilization and aid in transfer from a wheelchair to the folding shower seat?... 
- Figure 406.2 Counter Slope of Surface Adjacent to Curb Ramps – Drawing from the U.S. Access Board
- 
    
  
  11B-610.3.2 L-shaped seats
  The rear edge of an L-shaped seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (381 mm) minimum and 16 inches (406 mm) maximum from the seat wall. The rear edge of... 
- 
    
  
  11B-809.4.1 Subsequent bathrooms
  In residential dwelling units with more than one bathroom, when a bathtub is installed in the first bathroom in compliance with Section 11B-809.4 and a shower compartment is provided in... 
- 
    
  
  11B-608.5.1  Reserved
  [See subsections ...] 
- 
    
  
  1.1.4
  1.1.4 A maximum overall design running slope for exterior accessible ramps of 7.5% (1:13.3 or 1:13) is recommended.... 
- 
    
  
  5.1.2 Level or Sloped Entry
  Camp shelters providing roll-in access shall have a level or sloped entry that complies with the FSORAG Outdoor Recreation Access Route technical provisions if the camp shelter is in a campground... 
- 
    
  
  4.34.5.6 BATHTUB AND SHOWER ENCLOSURES
  Enclosures for bathtubs or shower stalls shall not obstruct controls or transfer from wheelchairs onto shower or bathtub seats.... 
- 
    
  
  Cross Slope [1016.7.2]
  Cross slope is the side-to-side slope of the surface of an ORAR.... 
- Starodub, Inc. Ultra-Light Inertial Profiler (ULIP) for Sidewalks
- 
    
  
  Sloped Surfaces
  One is the running slope that runs parallel to the direction of travel and the other is the cross slope, which runs perpendicular to the running slope.... 
