In load or unload areas and on amusement rides, where compliance with Section 11B-405.2 is not structurally or operationally feasible, ramp slope shall be permitted to be 1:8 maximum...
Search Results "Maximum Reach Depth"
-
11B-1002.2 Accessible routes
-
T504 Fare Collection Devices
A transit agency expressed concern that application of the requirements in this section, in conjunction with the maximum mounting height for operable parts specified in T304 (i.e., operable...
-
4.10.12(3)
(3) Height. All floor buttons shall be no higher than 54 in (1370 mm) above the finish floor for side approach and 48 in (1220 mm) for front approach. Emergency controls, including...
-
T304 Operable Parts
A commenter to the 2008 Draft Revised Vehicle Guidelines noted that some operable parts—such as those on stop request devices—are small and difficult to reach for some transit users....
-
Technically Infeasible
Technically Infeasible. With respect to an alteration of a building or a facility, something that has little likelihood of being accomplished because existing structural conditions...
-
TECHNICALLY INFEASIBLE
TECHNICALLY INFEASIBLE. An alteration of a building or a facility that has little likelihood of being accomplished because the existing structural conditions require the removal or...
-
1016.1 General
Outdoor recreation access routes shall comply with 1016. EXCEPTIONS: 1. In alterations to existing camping facilities, picnic facilities, and trailheads, when an entity determines...
-
Technically Infeasible
With respect to an alteration of a building or a facility, something that has little likelihood of being accomplished because existing structural conditions would require removing or...
-
1018.1 General
Beach access routes shall comply with 1018. EXCEPTIONS: 1. When an entity determines that a condition in 1019 does not permit full compliance with a specific provision in 1018 on...
-
§35.151(d)
(d) Alterations: Historic properties.
-
106.5.68 Technically Infeasible
With respect to an alteration of a building or a facility, something that has little likelihood of being accomplished because existing structural conditions would require removing or...
-
1016.1 General
Outdoor recreation access routes shall comply with 1016. EXCEPTIONS: 1. In alterations to existing camping facilities, picnic facilities, and trailheads, when an entity determines...
-
1018.1 General
Beach access routes shall comply with 1018. EXCEPTIONS: 1. When an entity determines that a condition in 1019 does not permit full compliance with a specific provision in 1018 on...
-
§ 35.151(b)(3)
(3)
-
What requirements of the standards apply in an alteration?
Where compliance is technically infeasible, compliance is required to the maximum extent feasible....
-
Figure 1007.3.2 Golf Club Reach Range Area – Drawing from the U.S. Access Board
-
General: ADA Standard Section 222.1
Section 222.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for dressing, fitting, and locker rooms.
-
11B-222.1 General
Where dressing rooms, fitting rooms, or locker rooms are provided, at least 5 percent, but no fewer than one, of each type of use in each cluster provided shall comply with Section...
-
11B-222.1 General
Where dressing rooms, fitting rooms, or locker rooms are provided, at least 5 percent, but no fewer than one, of each type of use in each cluster provided shall comply with Section...
-
Direct Access Solutions Kit
Hanging up their clothes in a standard closet Adjusting the thermostat to a comfortable temperature Locking and unlocking the security latch Making coffee and reaching...
-
4.1.6(3)(d)(i)
(i) Where it is technically infeasible to comply with clear opening width requirements of 4.13.5, a projection of 5/8 in maximum will be permitted for the latch side stop....
-
Exemptions for Entire Trail or Beach Access Route
The proposed rule would have exempted an entire trail from complying with the technical requirements for trails when: The combination of running slope and cross slope...
