requirement for vertical access, an accessible route within each story or mezzanine is still required to connect dining areas and other spaces and elements even though an elevator (or ramp...
Search Results "Curb Ramp Surface"
-
Dining Areas in Restaurants and Cafeterias
-
11B-244.1 General
The CBC requires raised areas of the facility to provide access by ramp, special access lift or elevator. ...
-
11B-244.1 General
The CBC requires raised areas of the facility to provide access by ramp, special access lift or elevator....
-
How can existing buildings be retrofitted to make them accessible?
At such facilities a separate ramp or an alternative entrance may have to be used. This may include adding an elevator or lift inside a two-story building....
-
F105.2.2 ASME
standard includes additional provisions for runway enclosures, electrical equipment and wiring, structural support, headroom clearance (which is 80 inches minimum), lower level access ramps...
-
A. Whether Sidewalks Are a Service Program, or Activity Covered by Title II of the ADA and Section 564 of the Rehabilitation Act
enacted an ordinance holding landowners responsible for adjacent sidewalks, the city had authority over its sidewalks such that it was required to draft a transition plan pertaining to curb...
-
18. Inspections
year of the Compliance Period, class counsel in the Carter/Fahmie Action shall be entitled to participate in the meetings, inspections and monitoring discussed herein, as they relate to curb...
-
Expert opinion on current literature
There is a consensus among studies that transferring to a higher surface implies greater exertion of the upper limb (3-6) . ...
-
Taking Measurements
Taking Measurements Sloped Surfaces One way to measure slope is to use a 24-inch level with leveling bubble and a tape measure....
-
What was measured and why?
Often, an unstable surface, for example, may be perceived as very difficult because of the unstable footing, even though the individual does not have to exert him/herself....
-
F203 General Exceptions
These provisions address circulation paths (206.2.8) and visual alarms (215.3), and include exceptions concerning technical specifications for accessible routes (403.5) and ramp handrails...
-
1009.5.4 Transfer Steps
The surface of the bottom tread shall extend to a water depth of 18 inches (455 mm) minimum below the stationary water level. Advisory 1009.5.4 Transfer Steps....
-
1009.5.2 Transfer Space
A transfer space of 60 inches (1525 mm) minimum by 60 inches (1525 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer platform surface and shall...
-
Tread Obstacles on Beach Access Routes
When the surface of the beach access route is paved or is built with boards, tread obstacles must not be more than a half of an inch (13 millimeters) high....
-
1018.5 Obstacles
Where the surface is other than concrete, asphalt, or boards, obstacles are permitted to not exceed 1 inch in height measured vertically to the highest point....
-
R308.1 Transit Stops
Transit stops should be located so that there is a level and stable surface for boarding vehicles....
-
Instrumentation for Analysis
Appendix C) was created to collect data on the 11 trail segments including Rotational Penetrometer readings, inspection location in feet from trailhead, ruts, tread obstacles, or other surface...
-
11B-812.7.2 Marking
The color of the borderlines, hatched lines, and letters shall contrast with that of the surface of the access aisle....
-
1018.2 Aisles in assembly spaces
for applications listed in Section 1.9.1 regulated by the Division of the State Architect-Access Compliance, shall also comply with Chapter 11A or Chapter 11B, Section 11B-403 _|Walking Surfaces...
-
Resting Intervals [1017.8]
When the surface of the resting interval is constructed of concrete, asphalt, or boards, the slope of the resting interval must be no steeper than 1:48 (2 percent) in any direction....
-
New Construction
Dining and Work Surfaces -- Sections 226 and 902. The provisions regarding accessible routes in section 206.2.5 (Restaurants and Cafeterias) also apply to dining surfaces....
-
Technical Requirements for Accessible Hiker/Pedestrian Trails
Section 7.4 of FSTAG explains the accessibility requirements for trails, including trail surfacing, clear tread width, grade and cross slope, resting intervals, passing spaces, tread obstacles...
-
Transit Stops (R308.1) (Section-by-Section Analysis)
The surfaces of boarding and alighting areas and boarding platforms must comply with the technical requirements for surfaces (see R302.7)....
-
F202.4 Alterations Affecting Primary Function Areas
function include the costs associated with-- (a) Providing an accessible route to connect the altered area and site arrival points, including but not limited to interior and exterior ramps...