proposes that, where the operable part is located 10 inches or less behind the vertical reference plane, the operable part must be 48 inches high maximum and 15 inches high minimum above the floor...
Search Results "Ground Floor Exit"
Filters
Commonly Searched Documents
-
407.12.2.1 Unobstructed Side Reach (Section-by-Section Analysis)
-
What access do I need?
◼ I need an exam table that lowers to 17–19 inches from the floor. ◼ I need help getting on and off the exam table. ◼ I need to bring my service dog....
-
11B-704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (864 mm) minimum above the finish floor....
-
11B-704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (864 mm) minimum above the finish floor....
-
Elkay Cane Apron LKAPREZL for use with EZ Bi-Level Drinking Fountains
This apron provides the mandatory 27" (686 mm) floor to underside requirement when mounted in this manner....
-
American Specialties 9018 Recess Mounted Stainless Steel Horizontal Baby Changing Station
For compliance with 2010 ADA Accessibility Standards, install unit so that top edge of changing table is 30-1/4" above finished floor (AFF)....
-
Nana Wall Systems, Inc. Folding Glass Walls SL60
The NanaWall SL60 delivers superior weather performance, beautiful aesthetic design, and offers an optional floor supported movement when installation conditions require it....
-
11B-224.8.2 More than 50-bed facilities
In sleeping rooms with more than 25 beds covered by this part, a minimum of 5% of the beds shall have clear floor space complying with section 806.2.3 of the 2010 Standards....
-
11B-205.1 General
Floor electrical receptacles shall not be required to comply with Section 11B-309. 5. HVAC diffusers shall not be required to comply with Section 11B-309. 6....
-
Jean Tessmer
I have specified and had this particular pocket door privacy latchset installed in new construction where I did not have enough door clear floor space for a swing door....
-
Department of Transportation Disability Law Guidance: Use of "Segways" on Transportation Vehicles
., 30 x 48 inches, measured two inches above the ground, and not exceeding 600 pounds, including the user) can reasonably be considered too large. ...
-
Data Collection Procedures
requirements of the 2010 Americans with Disabilities Act (ADA) Standards for Accessible Design and the Architectural Barriers Act (ABA) Accessibility Standards: 1008.2 Accessible Routes; 1008.2.6 Ground...
-
5. Compare Surface Options
Written description of the maintenance and frequency necessary to maintain the accessible route and clear ground spaces....
-
Accessible Boating Facilities
ADAAG addresses only the built environment (structures and grounds). The guidelines do not address operational issues of a facility....
-
18. Preemployment inquiries
Commenters representing handicapped persons strongly favored a ban on preemployment inquiries on the ground that such inquiries are often used to discriminate against handicapped persons...
-
Protruding Objects and Outdoor Recreation Access Routes
is not required for accessibility on outdoor recreation access routes, and it is not usually desirable in outdoor environments because it isn't as easy to see or detect objects near the ground...
-
Other Road and Shared Use Path Users
"Low rider" bicycles- Bicycles that have been customized for aesthetics to be low to the ground and often longer than standard bicycles....
-
3.2 Getting on the Table
Accessible tables and chairs that lower to 17-20 inches from the floor to the top of the cushion can make getting on and off them easier. ...
-
Halsey Taylor Cane Touch Apron for HAC ADA Series
Note: Floor to underside measurements of cane apron equals 27" when mounted correctly....
-
"Wheelchair" (Section-by-Section Analysis)
"Typical indoor and outdoor pedestrian areas" refer to locations and surfaces used by and intended for pedestrians, including sidewalks, paved paths, floors of buildings, elevators, and...
-
"Wheelchair" (Section-by-Section Analysis)
"Typical indoor and outdoor pedestrian areas" refer to locations and surfaces used by and intended for pedestrians, including sidewalks, paved paths, floors of buildings, elevators, and...
-
Kawneer North America AA™250/425 Thermal Entrances
8" typical wall thickness Dual welded corner construction Single acting Offset pivots, butt hinges or continuous geared hinge Surface mounted or concealed closers MS locks or exit...
-
Willoughby Industries WAW-2322-DMF AquaWave® Two Station Solid Surface Lavatory System for Deck Mounted Faucets
A floor kit is available for an installation that requires an on-floor pedestal....
-
Willoughby Industries WAW-2333-DMF AquaWave® Three Station Solid Surface Lavatory System for Deck Mounted Faucets
A floor kit is available for an installation that requires an on-floor pedestal....
