To determine site impracticality, the slope would be measured at ground level from the point of the planned entrance on a straight line to (1) each vehicular or pedestrian arrival point...
Search Results "Ground Floor Exit"
Filters
Commonly Searched Documents
-
TEST NO. 1 – INDIVIDUAL BUILDING TEST
-
TEST NO. 1 – INDIVIDUAL BUILDING TEST
To determine site impracticality, the slope would be measured at ground level from the point of the planned entrance on a straight line to (1) each vehicular or pedestrian arrival point...
-
11B-216.13.3 Conditions of use
Floor or wall coverings, floor or wall covering adhesives, carpets, formaldehyde-emitting particleboard cabinetry, cupboards or doors have not been installed or replaced in the previous...
-
Technical Memorandum TM 2017-25 Door and Gate Surfaces
TM 2017-25 Door and Gate Surfaces Effective Date: April 1, 2017 2012 TAS Reference: 404.2.10 404.2.10 requires door and gate surfaces within 10 inches (255mm) of the finish floor...
-
Lighting Contrast and Conceptual Design
And the whole [interior is] all white, clear white, everything white – the ceiling, the floor, the floor tiles, the wall, the columns, the furniture....
-
General [4.5.1]
Affected industries (floor finishes, ceramic tile, and plumbing fixtures) each employ a different testing method in designating the slip-resistance of their products....
-
11B-805.7 Built-in cabinets and work surfaces
A 30-inch by 48-inch clear floor space, in compliance with Section 11B-305, shall be centered in front of the display screen....
-
11B-604.8.1.1 Size
shall be 60 inches (1524 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1422 mm) deep minimum for wall hung water closets and 59 inches (1499 mm) deep minimum for floor...
-
704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (865 mm) minimum above the finish floor....
-
Detectable Warnings
This revision does not substantively change the requirements for the coordination of platforms and vehicle floors. 28 36 CFR part 1192...
-
Companion Seats
Consistent with the ANSI A117.1‒2003 standard, the provision in the final rule specifies that shoulder alignment is to be measured 36 inches from the front of the wheelchair space and that the floor...
-
1007.6.1 Size
Exception: The enforcing agency may reduce the size of each required area of refuge to accommodate one wheelchair space that is not less than 30 inches by 48 inches (762 mm by 1219 mm) on floors...
-
Substantive changes made to requirements for elevators
the proposed rule) modification of specifications for audible hall signals (407.2.2.3) and audible car position indicators (407.4.8.2) revision of the height of tactile floor...
-
Is it OK to examine a patient who uses a wheelchair in the wheelchair, because the patient cannot get onto the exam table independently?
A good option is to have a table that adjusts down to the level of a wheelchair, approximately 17‒19 inches from the floor....
-
Water Closet Location and Rear Grab Bar
., when a lavatory or other recessed fixture is located next to the water closet and the wall behind the lavatory is recessed so that the lavatory does not overlap the required clear floor...
-
Comparison of Single-User Toilet Room Layouts: Plan 3
An out-swinging door also minimizes the overall layout depth and cannot swing over the required clear floor space or clearance at any accessible plumbing fixture....
-
M301.2.1 Adjustability (Section-by-Section Analysis)
four additional transfer heights located between the low and high transfer heights, separated by one inch minimum increments; and (4) the transfer surface height will be measured from the floor...
-
608.3 Grab Bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor....
-
QUESTION: WHAT LIMITATIONS CAN A PVO IMPOSE WITH RESPECT
TO CARRYING A SERVICE ANIMAL?
* For example, a PVO could impose a legitimate safety requirement that a service dog not be permitted to enter a sauna or steam room, sit on any surface other than the floor, or join...
-
704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (865 mm) minimum above the finish floor....
-
610.3 Shower Compartment Seats
The top of the seat shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the bathroom finish floor. Seats shall comply with 610.3.1 or 610.3.2....
-
J. Drinking Fountains
When an object, such as a drinking fountain, protrudes more than four inches into the circulation path, the bottom edge must be at 27 inches above the floor or lower so the drinking fountain...
-
704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (865 mm) minimum above the finish floor....