actuator design provides superior reliability Integrated design incorporates all accesscontrol components, including card reader, door position switch and request-to-exit...
Search Results "Floor-Level Exit Sign"
-
Corbin Russwin Inc. SE LP10 Mortise Lock
-
§ 382.37 Seat assignments
(a) Carriers shall not exclude any qualified individual with a disability from any seat in an exit row or other location or require that a qualified individual with a disability sit in any...
-
Baby Changing Tables
The specified dimensions of toilet compartments provide the minimum amount of space necessary for wheelchair maneuvering into the compartment, positioning at the fixture, and exit from the...
-
1133B.5.4.5
SECTION 1133B GENERAL ACCESSIBILITY FOR ENTRANCES, EXITS AND PATHS OF TRAVEL 1133B.5 Ramps. 1133B.5.4.5 Landing width. ...
-
Elevated Accessible Routes
Elevated accessible routes must connect the entry and exit points of at least 50 percent of the elevated play components provided in the play area. ...
-
Visual Devices for the Fire Alarm System
Additional information that is provided over voice systems for a specific type of emergency such as a threatening weather event, or that directs people to use a specific exit, are unavailable...
-
5.9.2.2 Standing Supports on Dual Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations
The user can grab onto the standing support, gain access to the platform, position, and exit the platform....
-
In-swinging Bathroom Doors
The commenter noted that an in-swinging door makes it extremely difficult to enter and exit....
-
12. Reach Range
Are there towel racks or bars placed within 54" of the floor for side approach or 48" of the floor for forward approach so persons who use wheelchairs can approach and use the towel racks...
-
4.19.2 Height and Clearances
Lavatories shall be mounted with the rim or counter surface no higher than 34 in (865 mm) above the finish floor....
-
11B-809.10.8.7 Mirrors and towel bars
Where mirrors are provided the bottom edge of the reflective surface shall be 40 inches (1016 mm) maximum above the finish floor....
-
BACKGROUND
They found that drivers are more likely to yield at roundabout entrances than exits and when: (1) speeds are lower, (2) the pedestrian is more aggressive, and (3) when the pedestrian has...
-
§ 36.406(f)(1)
(1) Wheelchair and companion seating locations are dispersed to all levels of the facility that are served by an accessible route;...
-
410.4 Minimize Interference
ICT shall reduce interference with hearing technologies to the lowest possible level and shall conform to 410.4....
-
2.2 Surface
The type of surface should be appropriate to the setting and level of development....
-
407.2.2.2 Visible Signals
Visible signal fixtures shall be centered at 72 inches (1830 mm) minimum above the finish floor or ground....
-
Electronic instruments
Electronic instruments have been developed to measure floor flatness....
-
11B-1002.4.3 Gaps
Floors of amusement rides with wheelchair spaces and floors of load and unload areas shall be coordinated so that, when amusement rides are at rest in the load and unload position, the vertical...
-
1002.4.3 Gaps
Floors of amusement rides with wheelchair spaces and floors of load and unload areas shall be coordinated so that, when amusement rides are at rest in the load and unload position, the vertical...
-
1002.4.3 Gaps
Floors of amusement rides with wheelchair spaces and floors of load and unload areas shall be coordinated so that, when amusement rides are at rest in the load and unload position, the...
-
11B-1002.4.3 Gaps
Floors of amusement rides with wheelchair spaces and floors of load and unload areas shall be coordinated so that, when amusement rides are at rest in the load and unload position, the vertical...
-
11B-1002.4.3 Gaps
Floors of amusement rides with wheelchair spaces and floors of load and unload areas shall be coordinated so that, when amusement rides are at rest in the load and unload position, the vertical...
-
11B-1009.3.2 Submerged depth
Sloped entries shall extend to a depth of 24 inches (610 mm) minimum and 30 inches (762 mm) maximum below the stationary water level....
-
405.7 Landings
Ramps that do not have level landings at changes in direction can create a compound slope that will not meet the requirements of this document....