Make it easier to insert cards or connectors by providing a bevel around the slot or connector, or use cards or connectors which can be inserted in any orientation or which self-center or...
Search Results "Beveled Threshold"
Commonly Searched Documents
-
Paragraph (e) (Advisory Guidance)
-
T215 Communication Features
Second, a state-wide association of transit managers asked the Access Board to clarify how the VOMS 100 threshold applies to contractors that provide fixed route bus service for public transit...
- BEA Inc. MS08 Door Access Touchless Activation Sensor (Wave to Open)
- Cal-Royal Commander Clutch Mechanism COM Series Cylindrical Lockset
- Cal-Royal NM Series Extra Heavy Duty Mortise Lockset
- Allegion Schlage S200-Series Mechanical Locks with Tubular Interconnect
- Tile Tech Pavers® Traver-Pave™
- Willoughby Industries 2235 Series AquaDeck Lavatory Deck
-
Attachment B – Code References
When the adjusted construction cost is less than or equal to the current valuation threshold, as defined in Chapter 2, Section 202, the cost of compliance with 11B-202.4 shall be limited...
- Stanley Access Technologies Dura-Care 7000 Manual Door System
- Willoughby Industries 2250 AquaDeck Lavatory Deck Radiused Front
- Willoughby Industries 2240 AquaDeck Lavatory Deck Angled Front
- Allegion Von Duprin 55 Series Cross Bar Exit Devices
- Willoughby Industries 2230 Series AquaDeck Lavatory Deck
- Lift-U® LU12 Step/Platform Onboard Lift
-
Effective date: Triggering event. (Section-by-Section Analysis)
not have building codes applying to title III entities, while Kentucky and Chicago do not require building permits and certificates of occupancy for construction under certain monetary thresholds...
-
Section 1630.2(g) Disability
“This definition is of critical importance because as a threshold issue it determines whether an individual is covered by the ADA.” 2008 Senate Statement of Managers at 6....
-
1118B.4
Changes in level between 1/4 inch (6.4 mm) and 1/2 inch (12.7 mm) shall be beveled with a slope no greater than one unit vertical in 2 units horizontal (50-percent slope) [see Figure 11B...
-
b. Exception for Base Support Allowance and Unobstructed Knee and Toe Space
Therefore, the final rule requires that from 25 inches to 28 inches measured from the leading edge of the breast platform, the height of the component above 1½ inches must be beveled at...
- Bradley Standard Series Vertical Recessed Soap Dispenser
- Cal-Royal Apollo ALC Series Cylindrical Lockset
-
Expert Report of Douglas J. Anderson, RAS, CASP, LCM Architects (August 8, 2018)
Building Entrance: The raised threshold at the exterior entrance exceeds 1/2 inch (1991 ADA Stds 4.13.8; 2010 ADA Stds 404.2.5)....
-
1124B
Changes in level between 1/4 inch (6.4 mm) and 1/2 inch (12.7 mm) shall be beveled with a slope no greater than one unit vertical in 2 units horizontal (50-percent slope) [see Figure 11B...