This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...
Search Results "Flared Side"
- Access Board: Tactile Sign Location
-
M303.2.3.3 Side Entry
Where wheelchair space entry is only from the side, the wheelchair space shall be 60 inches (1525 mm) deep minimum....
-
M305.2.3 Height (Section-by-Section Analysis)
The MDE Advisory Committee explained that the manufacturers on the Committee determined that this recommendation did not conflict with the IEC 60601-2-52, which provides requirements for side...
-
How to Measure Transfer Surface Height
In the diagram below, the upper wheelchair illustrates a typical side transfer, which may optionally utilize a transfer board....
-
Forward and Side Approaches
At most elements, clear floor space can be positioned for either a forward approach or a side approach....
-
5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2
considering whether the above cross section dimensions would be appropriate for the gripping surfaces of transfer supports on diagnostic equipment used by patients in a supine, prone, or side-lying...
-
How Can You Overcome These Barriers to Work with Your Providers?
There are many things that a person with a disability can do to improve his or her quality of health care and break down the barriers that compromise care. The following suggestions...
-
5.1.4 Transfer Surface Height Measurement for M301 and M302
Rationale for final recommendation Having an accessible transfer surface height is critical to facilitate independent patient transfers to equipment used by patients both in a supine, side-lying...
-
11B-406.5.2 Width
The clear width of curb ramp runs (excluding any flared sides), blended transitions, and turning spaces shall be 48 inches (1219 mm) minimum....
-
11B-406.5.2 Width
The clear width of curb ramp runs (excluding any flared sides), blended transitions, and turning spaces shall be 48 inches (1219 mm) minimum....
- Georgia-Pacific Compact® Brushed Steel Finish Side-By-Side Double Roll Bathroom Tissue Dispenser 56796
-
5.4.3 Transfer Support Height for M301 and M302
whether 6 inches minimum and 19 inches maximum above the transfer surface would be an appropriate height for transfer supports on diagnostic equipment used by patients in a supine, prone, or side-lying...
-
Side guard protocol
Percentage of subjects that were able to attain a certain height in the side guard protocol Height (in) % Subjects Side guard 10...
- Brewer Access™ High-Low Exam Table
-
Sides of Curb Ramps [§406.3]
Sides of Curb Ramps [§406.3] Curb ramps can have returned sides, but a top landing is required under all conditions to allow maneuvering to and from the run....
- Behavioral Safety Products #GB350 Suicide Resistant Safety Grab Bar with Full Closure Plate
- Brey-Krause Concealed Mounting Security / Anti Suicide Grab Bars
-
M305.2.2 Length
The length of transfer supports shall comply with M305.2.2.1 or M305.2.2.2.
-
M301.2.1 Height
The height of the transfer surface during patient transfer shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum measured from the floor to the top of the transfer...
-
5.1 Transfer Surface Height Recommendations
The height provision is the same for MDE used by patients in supine, prone, or side-lying positions (M301) and patients in seated positions (M302)....
-
11B-1002.4.4.2 Side entry
Where wheelchair spaces are entered only from the side, amusement rides shall be designed to permit sufficient maneuvering clearance for individuals using a wheelchair or mobility aid to...