The size of the clear ground space is based on the dimensions for maneuvering clearance at clear floor or ground spaces that are confined on all or part of three sides in 305.7 of the Architectural...
Search Results "Floor Slope"
-
1011.2.1 Size and Location
-
11B-703.5.5 Character height
Exception: Where provided, floor plans providing emergency procedures information in accordance with Title 19 shall not be required to comply with Section 11B-703.5.5....
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
11B-608.6 Shower spray unit and water
One shower head shall be located at a height of 48 inches (1219 mm) maximum above the shower finish floor....
-
11B-703.5.5 Character height
Exception: Where provided, floor plans providing emergency procedures information in accordance with Title 19 shall not be required to comply with Section 11B-703.5.5....
-
11B-608.6 Shower spray unit and water
One shower head shall be located at a height of 48 inches (1219 mm) maximum above the shower finish floor....
-
ALIGNMENT OF 19-INCH RECOMMENDATION WITH ACCESS BOARD PROPOSED RULEMAKING
proposed rule, the Access Board proposed that the “height of the transfer surface during patient transfer shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum measured from the floor...
-
ADDENDUM TO PHASE I FINAL REPORT: Points of Clarification
One subject could not transfer higher or lower than their device's seat to floor height. ...
-
Willoughby Industries ASWLDR-1922 Ligature-resistant Stainless Steel Behavioral Healthcare Lavatory System
The lavatory system with integral sloped backsplash and integral ligature-resistant side splashes shall be rounded to minimize its use as a ligature point....
-
Sides of Curb Ramps
Section 406.3 addresses the sides of curb ramps and specifies that side flares, where provided, have a slope of 1:10 maximum....
-
Mobility
Activities that may be difficult for people with mobility disabilities include walking, climbing steps or slopes, standing for extended periods of time, reaching, and fine finger manipulation...
-
D) Curb Ramps at Intersections
When walkways cross a curb at intersections, a ramp or sloped surface is needed. The title II regulations set requirements for curb ramps at intersections....
-
Demographic Questionnaire Data
Very Satisfied 8 Biggest Complaint About Pathways Roughness 27 Cross Slope...
-
Kohler Veil™ One-Piece Elongated Dual-Flush Wall-Hung Toilet With Reveal® Quiet-Close™ Seat
Veil™ The Veil wall-hung toilet saves up to 12 inches of precious bathroom space over KOHLER's longest floor-mount models....
-
Hill-Rom Liko® M220 / M230 Mobile Lift
Basic lifting needs for most patient types Lifting Needs With the Liko® M220 and M230 mobile lifts, you can meet all of the most common lifting needs, including lifting from the floor...
-
Where must the wheelchair symbol be posted?
Rest rooms The ISA and gender designation must be posted at all accessible rest rooms on the wall beside the latch side of the door, 60 inches above the floor....
-
Spaces and Elements: ADA Standard Section 206.2.4
Section 206.2.4 covers the scoping requirements in the most current ADA Standards for accessible routes connecting spaces and elements within a building.
-
Height Requirements
revised to specifically cover operable parts that are "intended for use only by service or maintenance personnel," "electrical or communication receptacles serving a dedicated use," and "floor...
-
1132A.5.1 General
The floor or landing on the dwelling unit side of the primary entry door and any required exit door shall have a minimum length of not less than 44 inches (1118 mm)....
-
106 Definitions
unnecessary, in most cases due to changes in certain scoping or technical requirements: "accessible route," "area of refuge," "automatic door," "destination-oriented elevator," "ground floor...
-
18. Where an existing ground level play component is replaced, should the new component comply with the technical provisions of Section 1008.4 even if there is not an accessible route to it?
In this case, the spring rocker being replaced would need to have the rocker seat height between 11 and 24 inches and clear floor or ground space and maneuvering space provided adjacent...
-
16. If a play surface is replaced with an accessible surface and the existing ground level play components are not accessible, do the components need to be replaced?
If the alteration to the play area only involves the surfacing, only the surface along accessible routes, clear floor or ground spaces, and maneuvering spaces must comply with the ASTM F...
-
4.3.11.2 Size
EXCEPTION: The appropriate local authority may reduce the minimum number of 30-inch by 48-inch (760 mm by 1220 mm) areas to one for each area of rescue assistance on floors where the occupant...
-
General [9.1.1]
Objects with leading edges above 27 inches and below 80 inches above the floor cannot project more than 4 inches unless there is a tactile cane detectable cue below the object....
