Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (229 mm) above the finish floor or ground....
Search Results "Maximum Dimension"
-
11B-306.3.2 Maximum depth
-
11B-306.3.2 Maximum depth
Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (229 mm) above the finish floor or ground....
-
409.4.1 Inside Dimensions of Elevator Cars
409.4.1 Inside Dimensions of Elevator Cars. Elevator cars shall provide a clear floor space of 36 inches (915 mm) minimum by 48 inches (1220 mm) minimum and shall comply with 305....
-
Are the elements of path of travel and accessible routes substantively the same (such as slope, vertical clearance, width of path of travel, etc.)?
Compliance is required to the maximum extent feasible without exceeding 20 percent of the cost of the work directly associated with the installation of EVCS (see Section 11B-202.4 Exception...
-
Types of Maximum Leave Policies
Types of Maximum Leave Policies Maximum leave policies (sometimes referred to as "no fault" leave policies) take many different forms....
-
Car Dimensions and Doors: ADA Standard Section 408.4.1
Section 408.4.1 covers the current ADA Standards for the car dimensions and doors of limited-use/limited-application elevators.
-
408.4.1 Car Dimensions and Doors
Figure 408.4.1 Limited-Use/Limited-Application (LULA) Elevator Car Dimensions...
-
4.1 Wheeled Mobility Device Dimensions
The maximum values for the UDI, Seeger and IDEA studies are just slightly above the standard value....
- Brady Worldwide Reserved Parking Maximum Fine of $100 For Use By Others Sign 127470
-
Conditions for Exceptions
[See subsections ...]
-
Conditions for Exceptions [1019]
The ABA Standards recognize the existence of constraints and limitations in the outdoor environment and allow for exceptions from specific provisions in the technical requirements...
-
1019.1 General
This section lists the conditions for the exceptions to specific provisions in 1011, 1013, 1014, 1015, 1016, 1017, and 1018. When an entity determines that any of the following...
-
§ 35.151(k)(2) Alterations to detention and correctional facilities.
(2) Alterations to detention and correctional facilities. Alterations to jails, prisons, and other detention and correctional facilities shall comply with the 2010 Standards except...
-
3.3 Comparison of Dimensions with Standards and other Anthropometric Studies
3.3 Comparison of Dimensions with Standards and other Anthropometric Studies...
-
2.2.2 Structural Anthropometry (i.e. Body and WhMD Dimensions)
Body and WhMD Dimensions) A three-dimensional (3-D) electromechanical probe (i.e....
-
810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60...
-
LEGAL OPINION - U.S. DEPARTMENT OF TRANSPORTATION OFFICE of GENERAL COUNSEL on 49 CFR 37.43(a)
May 2016
-
§ 37.43(a)
(a)
-
Appendix 3 - Comparison of US Standards to IDEA Center Research
Appendix 3 - Comparison of US Standards to IDEA Center Research Dimension U.S....
-
2.3.3 Comparison of Dimensions with Standards and other Anthropometric Studies
• Maximum Forces for Hand-operated Controls: Compared to the maximum hand grip strength in a power grip, and lateral and thumb-forefinger pinch grips....
-
1016.7.1 Maximum Running Slope and Segment Length
Where the running slope of a segment of an outdoor recreation access route is steeper than 1:20 (5%), the maximum length of the segment shall be in accordance with Table 1016.7.1, and a...
-
1018.7.1 Maximum Running Slope and Segment Length
Where the running slope of a segment of a beach access route is steeper than 1:20 (5%), the maximum length of the segment shall be in accordance with Table 1018.7.1, and a resting interval...
-
1016.7.1 Maximum Running Slope and Segment Length
Where the running slope of a segment of an outdoor recreation access route is steeper than 1:20 (5%), the maximum length of the segment shall be in accordance with Table 1016.7.1, and a...
-
1018.7.1 Maximum Running Slope and Segment Length
Where the running slope of a segment of a beach access route is steeper than 1:20 (5%), the maximum length of the segment shall be in accordance with Table 1018.7.1, and a resting interval...