Wheelchair spaces shall provide a clear width of 30 inches (760 mm) minimum and a clear length of 48 inches (1220 mm) minimum measured to 9 inches (230 mm) minimum above the floor surface...
Search Results "Kitchen Work Surface"
-
1002.4.4.1 Width and Length
-
1009.2.4 Seat Height
The height of the lift seat shall be designed to allow a stop at 16 inches (405 mm) minimum to 19 inches (485 mm) maximum measured from the deck to the top of the seat surface when in the...
-
11B-805.6 Hand washing fixtures, lavatories and sinks
The sink is the actual area where work is performed as opposed to a place where the employee cleans up before and after performing work elsewhere in the room....
-
11B-805.6 Hand washing fixtures, lavatories and sinks
The sink is the actual area where work is performed as opposed to a place where the employee cleans up before and after performing work elsewhere in the room....
-
11B-202.3 Alterations
In Legal Opinion No. 94-1109, dated May 10, 1995, the Attorney General for the State of California concluded that seismic strengthening work in an existing building constitutes a “building...
-
11B-202.3 Alterations
In Legal Opinion No. 94-1109, dated May 10, 1995, the Attorney General for the State of California concluded that seismic strengthening work in an existing building constitutes a “building...
-
Kompan, Inc. M175 - Water Lilies Spring Rider
The Water Lilies is all about working together....
-
Don-Jo Mfg., Inc. 5" Hospital Latch 4550
Number 4550 Back set 5" Material Brass Size 2-3/4" x 4-1/2" Shelf pack 1 Features UL Listed, Works...
-
H.3 - If an agency began work on EIT prior to June 21, 2001 that will be developed entirely in-house, but won't be completed until after June 21, 2001, does this EIT have to meet the 508 requirements?
Yes. The Access Board's standards for EIT became effective February 20, 2001 and apply to EIT that is developed, procured, maintained or used by the Federal government, whether...
-
Service Animals
Under the ADA’s revised regulations, the definition of “service animal” is limited to a dog that is individually trained to do work or perform tasks for an individual with a disability....
-
Comfort animals vs. psychiatric service animals.
Under the Department's present regulatory language, some individuals and entities have assumed that the requirement that service animals must be individually trained to do work or perform...
-
NOTES
Note that height measurement, as defined by the tables and chairs subcommittee, represents the highest point of the transfer surface, inclusive of bolsters, when measuring to the top of...
-
303 Changes in Level
Section 303 addresses vertical changes in level in floor or ground surfaces. No changes have been made to this section....
-
12162(a)(4)(B)(ii)
(ii) appropriate auxiliary aids and services, including a hard surface on which to eat, shall be provided to ensure that other equivalent food service is available to individuals with disabilities...
-
7.4.4.3 Slope
Where the surface is paved or is elevated above the natural ground, the slope shall not be steeper than 1:48 (2 percent) in any direction. ...
-
A4.13.8 Thresholds at Doorways
Thresholds and surface height changes in doorways are particularly inconvenient for wheelchair users who also have low stamina or restrictions in arm movement because complex maneuvering...
-
2.8 Openings
Openings in the surface of ORARs shall be small enough to prevent passage of a 1/2 inch (13 mm) diameter sphere....
-
4.1.7(2)(e)
., books, should be no higher than 44 in (1120 mm) above the floor surface....
-
A4.13.8 THRESHOLDS AT DOORWAYS
Thresholds and surface height changes in doorways are particularly inconvenient for wheelchair users who also have low stamina or restrictions in arm movement, because complex maneuvering...
-
1009.5.7 Grab Bars
Where a grab bar is provided on each step, the tops of gripping surfaces shall be 4 inches (100 mm) minimum and 6 inches (150 mm) maximum above each step and transfer platform....
-
1016.5 Obstacles
EXCEPTION: Where the surface is other than asphalt, concrete, or boards, obstacles shall be permitted to not exceed 1 inch (25 mm) in height measured vertically to the highest point....
-
11B-1002.5 Amusement ride seats designed for transfer
Where possible, designers are encouraged to locate the ride seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
1002.5 Amusement Ride Seats Designed for Transfer
Where possible, designers are encouraged to locate the ride seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
Transfer Platforms
can use to lift or transfer onto the play structure and leave the wheelchair or mobility device behind at ground level. 11 inches (280 mm) to 18 inches (455 mm) height of top surface...
