The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
Search Results "Minimum Dimension"
-
11B-610.3 Shower compartment seats
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, operable parts of controls and faucets shall be installed on the side wall of the compartment adjacent to the seat wall 19 inches (483 mm) minimum...
-
Communication Features in Guest Rooms
The Board had proposed increasing the minimum number of such guest rooms to 50% of the total number of guest rooms provided....
-
5.9.1 Standing Supports Recommendation In Reference To Mammography Equipment
To be useful, positioning supports must be shaped for grasping, positioned within reach range of all users, and be 12 inches long minimum when located on the moving c-arm or 18 inches long...
-
Standing Supports [M305.2]
To be useful, positioning supports must shaped for grasping, positioned within the reach range of all users, and be 12 inches long minimum when located on the moving c-arm or 18 inches long...
-
Protocol A Heights Obtained
20 14 10 10 Table E4 Alternative Text Description: This table shows the attainable height percentiles for Protocol A minimum...
-
11B-703.5.5 Character height
Minimum character height shall comply with Table 11B-703.5.5....
-
Conclusion
Where the playground surface fails to comply with the minimum accessibility standards, children with mobility impairments may be regulated to the sidelines only to look on. ...
-
Accessible Routes - Interior and Exterior
Requirements: At least one route that is a minimum of 36 inches wide without steps, stairs, or other abrupt level changes must be provided within the boundary of the lodging facility's...
-
11B-703.5.5 Character height
Minimum character height shall comply with Table 11B-703.5.5....
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, operable parts of controls and faucets shall be installed on the side wall of the compartment adjacent to the seat wall 19 inches (483 mm) minimum...
-
11B-703.5.5 Character height
Minimum character height shall comply with Table 11B-703.5.5....
-
3.3 Guidance on the Visual Properties of Detectable Warnings
A detectable warning that provides a minimum luminance contrast of 60 percent could be seen from a distance of 2.44 m (8 ft) by approximately 92 percent of the pedestrians with visual impairments...
-
Acceleration
The AASHTO Guide for the Development of Bicycle Facilities (p. 65) uses a bicycle acceleration rate of 0.5 to 1 m/sec2 (1.5 to 3.0 ft/sec2) in its equation to determine the minimum green...
-
Sweep Width
The AASHTO Guide for the Development of Bicycle Facilities (pg. 22) recommends a minimum width for bike lanes as 1.2 m (4 ft).(2) Additionally it recommends (pp. 35-36) a minimum width of...
-
Section 36.406 Standards for New Construction and Alterations (Section-By-Section Analysis and Response to Comments)
which require the Attorney General to promulgate standards for accessible design for buildings and facilities subject to the Act and this part that are consistent with the supplemental minimum...
- American Standard Madera 1.28 gpf ADA Toilet with Exposed Manual Flush Valve System
- American Standard Madera 1.6 gpf ADA Toilet with Exposed Manual Flush Valve System
- Bradley Grab Bars 1 1/2" with Concealed Mounting 812
- SafePath BigHorn™ Ramps
- Allegion aptiQ SM10 Smart Mini-Mullion Reader
- Delta Single Handle Pull-Down Bar/Prep Faucet with Touch2O Technology 9959T-DST
- SafePath VulcanLanding™ Rubber Transition Ramp