Not more than 6 inches of the required clear floor space may be accommodated for footrests under another seat provided there is a minimum of 9 inches from the floor to the lowest part of...
Search Results "Minimum Dimension"
-
§ 38.23(d)(2) Location and size
-
11B-806.2.3 Sleeping areas
At least one sleeping area shall provide a 36 inch (914 mm) by 48 inch (1219 mm) minimum clear space on both sides of a bed....
-
11B-502.6.4.2
The parking space shall be outlined in blue or painted blue and shall be marked with an International Symbol of Accessibility complying with Section 11B-703.7.2.1 a minimum 36 inches wide...
-
11B-607.6 Shower spray unit and water
A shower spray unit with a hose 59 inches (1499 mm) long minimum that can be used both as a fixed-position shower head and as a hand-held shower shall be provided....
-
11B-806.2.3 Sleeping areas
At least one sleeping area shall provide a 36 inch (914 mm) by 48 inch (1219 mm) minimum clear space on both sides of a bed....
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, operable parts of controls and faucets shall be installed on the side wall of the compartment adjacent to the seat wall 19 inches (483 mm) minimum...
-
Communication Features in Guest Rooms
The Board had proposed increasing the minimum number of such guest rooms to 50% of the total number of guest rooms provided....
-
5.9.1 Standing Supports Recommendation In Reference To Mammography Equipment
To be useful, positioning supports must be shaped for grasping, positioned within reach range of all users, and be 12 inches long minimum when located on the moving c-arm or 18 inches long...
-
Standing Supports [M305.2]
To be useful, positioning supports must shaped for grasping, positioned within the reach range of all users, and be 12 inches long minimum when located on the moving c-arm or 18 inches long...
-
Protocol A Heights Obtained
20 14 10 10 Table E4 Alternative Text Description: This table shows the attainable height percentiles for Protocol A minimum...
-
11B-703.5.5 Character height
Minimum character height shall comply with Table 11B-703.5.5....
-
Conclusion
Where the playground surface fails to comply with the minimum accessibility standards, children with mobility impairments may be regulated to the sidelines only to look on. ...
-
Accessible Routes - Interior and Exterior
Requirements: At least one route that is a minimum of 36 inches wide without steps, stairs, or other abrupt level changes must be provided within the boundary of the lodging facility's...
-
11B-703.5.5 Character height
Minimum character height shall comply with Table 11B-703.5.5....
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, operable parts of controls and faucets shall be installed on the side wall of the compartment adjacent to the seat wall 19 inches (483 mm) minimum...
-
11B-703.5.5 Character height
Minimum character height shall comply with Table 11B-703.5.5....
-
3.3 Guidance on the Visual Properties of Detectable Warnings
A detectable warning that provides a minimum luminance contrast of 60 percent could be seen from a distance of 2.44 m (8 ft) by approximately 92 percent of the pedestrians with visual impairments...
-
Acceleration
The AASHTO Guide for the Development of Bicycle Facilities (p. 65) uses a bicycle acceleration rate of 0.5 to 1 m/sec2 (1.5 to 3.0 ft/sec2) in its equation to determine the minimum green...
-
Sweep Width
The AASHTO Guide for the Development of Bicycle Facilities (pg. 22) recommends a minimum width for bike lanes as 1.2 m (4 ft).(2) Additionally it recommends (pp. 35-36) a minimum width of...
-
Section 36.406 Standards for New Construction and Alterations (Section-By-Section Analysis and Response to Comments)
which require the Attorney General to promulgate standards for accessible design for buildings and facilities subject to the Act and this part that are consistent with the supplemental minimum...
-
Door King Inc. 1837 PC Programmable Telephone Entry and Access Control System
Dimensions Surface Mount: 13"H x 11.25"W x 4.75"D. Dimensions Flush Mount: 13.25"H x 12"W x 3.25"D. Dimensions Wall Mount: 15"H x 13.25"W x 3.5"D....
