the state through the use of federal money, the owner of the building or facility, or the owner's designated agent, must present to the commission the proof required by Subsection (a)(2)...
Search Results "Grade 2 Braille"
-
Sec. 469.151(b)
-
A1
Is a relatively level (1:50 or 2% maximum slope in all directions) access aisle provided adjacent and parallel to the side of the vehicle pull-up area?...
-
B5
Are all accessible parking spaces, including the access aisle, relatively level (1:50 or 2%) in all directions?...
-
4.2.8 Slope
The slope of the clear floor or ground space required by section 4.2.6 shall not exceed 1:48 (2 percent) in any direction. Exception....
-
4.6.5 Slope
The slope of the clear floor or ground space required by section 4.6.4 shall not exceed 1:48 (2 percent) in any direction. Exception....
-
1018.6 Openings
Openings in the surface of beach access routes and resting intervals shall not allow the passage of a sphere more than 1/2 inch (13 mm) in diameter. Advisory 1018.6 Openings....
-
1017.6 Openings
section requires openings in the surface of trails, passing spaces, and resting intervals such as spaces between the boards in a boardwalk to not allow passage of a sphere more than 1/2...
-
4.7.3 Slope
The slope of the clear floor or ground spaces required by section 4.0 shall not exceed 1:48 (2 percent) in any direction. Exception....
-
1017.6 Openings
Openings in the surface of trails, passing spaces, and resting intervals shall not allow the passage of a sphere more than 1/2 inch (13 mm) in diameter. Advisory 1017.6 Openings....
-
11B-208.2.3.2 Additional parking spaces for residents
Where the total number of parking spaces provided for each residential dwelling unit exceeds one parking space per residential dwelling unit, 2 percent, but no fewer than one space, of all...
-
11B-208.2.3.2 Additional parking spaces for residents
Where the total number of parking spaces provided for each residential dwelling unit exceeds one parking space per residential dwelling unit, 2 percent, but no fewer than one space, of all...
-
[ADA Title III §36.104] Commerce
[ADA Title III §36.104] Commerce means travel, trade, traffic, commerce, transportation, or communication – (1) Among the several States; (2) Between any foreign country or any territory...
-
Best Way to Use CA Inter Advanced Accounting Notes
2 hours) Revise previous chapter notes Active recall Evening (1–2 hours) Mixed revision Solve past exam questions Consistency beats intensity...
-
ClickAndGo Tactile Maps
Labeled in Braille, they also utilize an easy-to-read tactile-visual symbol system and include large print, high-contrast displays....
-
Observations and Results
Approximately 60 children in grades 4 and 5 (ages 9 to 11) were divided into three groups and then invited to play on each test surface....
-
Is it prohibited to draw majority-minority districts?
One such justification may be the need to remedy a violation of Section 2 of the Voting Rights Act....
-
SPECIFIC RELIEF
. § 12188(b)(2)(B); 28 C.F.R. § 36.504(a)(2). ...
-
MONETARY RELIEF FOR THE COMPLAINANT
. § 12188(b)(2)(B); 28 C.F.R. § 36.504(a)(2). 26....
-
401.1 Scope (Section-by-Section Analysis)
401.1 Scope (Section-by-Section Analysis) This section proposes that the technical requirements for hardware in Chapter 4 be applied where (a) required by 508 Chapter 2 or 255 Chapter...
-
6.1(4)(a)
The percentage of accessible rooms provided shall be consistent with the percentage of rooms required to be accessible by the applicable requirements of 6.1(1), 6.1(2), or 6.1(3), until...
-
407.12.3.2.2 Knee and Toe Space
provide a clear height of 9 inches (230 mm) minimum above the floor and a clear depth of 6 inches (150 mm) maximum from the vertical reference plane toward the leading edge of the ICT. 2....
-
1. Introduction
Chapter 2 presents an overview of the methodology for calculating the costs attributed to the final rule and how the methodology is applied for calculating the costs for all movie theaters...
-
1.1.6 Flatness of walk cross slope
See Fig. 2. If the path is less than 6 ft (1.8 m) wide the ends of the measurement will overlap at each interval....
