Handrail gripping surfaces with a non-circular cross section shall have a perimeter dimension of 4 inches (100 mm) minimum and 6¼ inches (160 mm) maximum, and a cross-section dimension of 2¼...
Search Results "Grade 2 Braille"
Filters
Commonly Searched Documents
-
505.7.2 Non-Circular Cross Sections
-
12204(c)(3) Other sites
equivalent to those established by 4.1.7(1) (b) and (c) of the Uniform Federal Accessibility Standards, and shall require, at a minimum, compliance with the requirements established in 4.1.7(2)...
-
3001.1 Scope
Exception: [DSA-AC] For accessibility requirements for platform lifts and elevators, see California Code of Regulations, Title 8 and Title 24, Part 2, Chapter 11B, Sections 11B-206.6,...
-
Public entity
Public entity means -- (1) Any State or local government; (2) Any department, agency, special purpose district, or other instrumentality of a State or States or local government; and...
-
§382.29(c)(1)
(1) If you determine that a person meeting the criteria of paragraph (b)(2), (b)(3) or (b)(4) of this section must travel with a safety assistant, contrary to the individual's self-assessment...
-
Comparison of Single-User Toilet Room “Pairs” With Fixtures Side-by-Side: Plan 2C
of Single-User Toilet Room “Pairs” With Fixtures Side-by-Side: Plan 2C 2010 Standards Plan-2C Pair: 2010 Standards with In-Swinging Doors Two 7’-2"...
-
(11) the City's ongoing failure to adopt any written policy or procedure
Dkt. 662, 13:15-11.2 2. Aside from a brief reference to the adequacy of the City's transition plan, the FAC does not specifically reference any of the above policies....
-
Cross Slope [1018.7.2]
When beach access routes are constructed of asphalt, concrete, or boards, the cross slope must be no steeper than 1:48 (2 percent)....
-
Sell-outs in specific seating areas. (Section-by-Section Analysis)
Under the second option, § 35.138(f)(2), a facility could release unsold accessible seating in a specific seating area once all of the standard seats in that location were sold out. ...
-
8. Gap
Is the gap between the wall and the inside face of each grab bar exactly 1 1/2" to accommodate persons with disabilities who rest their forearms on the bars for stabilization so the arm...
-
K. Ambulatory Stall
If there are more than 5 stalls in any restroom, is there one stall in addition to the large accessible stall, that is 36" wide, has 2 parallel grab bars at 33"-36" off the floor and has...
-
609.2.2 Non-Circular Cross Section
Grab bars with non-circular cross sections shall have a cross-section dimension of 2 inches (51 mm) maximum and a perimeter dimension of 4 inches (100 mm) minimum and 4.8 inches (120 mm)...
-
4(5)
(5) Exterior deck, patio, or balcony surfaces are no more than 1/2 inch below the floor level of the interior of the dwelling unit, unless they are constructed of impervious material such...
-
904.3.2 Counter
The top of the counter edge protection shall be 2 inches (51 mm) maximum above the top of the counter surface on the aisle side of the check-out counter....
-
§ 36.105(d)(1)(ix)
(ix) The six-month “transitory” part of the “transitory and minor” exception in paragraph (f)(2) of this section does not apply to the “actual disability” or “record of” prongs of the definition...
-
Public entity
Public entity means— (1) Any State or local government; (2) Any department, agency, special purpose district, or other instrumentality of a State or States or local government; and...
-
12204(c)(3) Other sites
equivalent to those established by 4.1.7(1)(b) and (c) of the Uniform Federal Accessibility Standards, and shall require, at a minimum, compliance with the requirements established in 4.1.7(2)...
-
D4. Door Clearance
[ADA Stds 4.13.6, figure 25] Note: The maximum threshold height is 1/2 inch for new construction....
-
R304.3.2 Running Slope
The running slope of the turning space shall be 2 percent maximum....
-
4.10.2 Automatic Operation
Each car shall be equipped with a self-leveling feature that will automatically bring the car to floor landings within a tolerance of 1/2 in (13 mm) under rated loading to zero loading conditions...
-
4.10.2 AUTOMATIC OPERATION
Each car shall be equipped with a self-leveling feature that will automatically bring the car to floor landings within a tolerance of 1/2 in (13 mm) under rated loading to zero loading conditions...
-
FAQ: How do I share content?
Click on the "Share Page" button on any page in Corada. 2....
-
What happens when people walk under more difficult conditions?
In general, when people walk under more difficult conditions there is: 1) a decrease in speed (to decrease the energy required), 2) an increase in heart rate (to pump more oxygen to the...