and shall extend the width of the boat slip, where the facility has at least one boat slip complying with 1003.3, and further compliance with 1003.3 would result in a reduction in the number...
Search Results "ANI: Automatic Number Identification"
Filters
Commonly Searched Documents
-
1003.3.1 Boat Slip Clearance
-
F233.1 General
Section F233 is not a stand-alone section; this section only addresses the minimum number of residential dwelling units within a facility required to comply with Chapter 8....
-
Picnic Tables [1011.2 and 1011.4]
The number of wheelchair spaces that must be provided at each table is based on the usable table surface perimeter....
-
Selection of Variables
Planning and executing even a relatively small anthropometric survey is a costly undertaking and if it is to be done, the addition of a reasonable number of variables for which there will...
-
Examination Tables
The number of each type of table made by the manufacturers, the number of tables included in the sample, and range of lower cost and higher cost products are summarized below....
-
Assisted Living Directory - Top Assisted Living Markets - Las Vegas, Nevada Assisted Living: Featured Facilities & Services
***There are a number of helpful local and statewide aging services for families and caregivers to take advantage of....
-
Visitability
–The relevant VisitAbility factor is a high number of visitable houses built, not a high number of features within a house....
-
SECTION 504 OF THE REHABILITATION ACT OF 1973 POLICY INTERPRETATION NO. 3
Mobility impaired persons may be provided access to the library's services through a bookmobile or by special messenger service or clerical aid or any other method that makes the resources...
-
6.3
6.3 Wheelchair spaces shall be integrated into their seat row and shall not be separated by any aisle or other break from the companion seat in the same row....
-
1630.4(i)
(i) Any other term, condition, or privilege of employment....
-
1630.16(d)
Such restrictions do not violate any provision of this part....
-
5.6 Testing
5.6 Testing Employers may use any kind of test to determine job qualifications. The ADA has two major requirements in relation to tests:...
-
609.5 Surface Hazards
Grab bars and any wall or other surfaces adjacent to grab bars shall be free of sharp or abrasive elements and shall have rounded edges....
-
Sec.36.503(b)
(b) Any person or group of persons has been discriminated against in violation of the Act or this part and the discrimination raises an issue of general public importance....
-
7. MISCELLANEOUS:
MISCELLANEOUS: Longer appointment Reason: Dietary* Specify: Ask if there are any additional needs...
-
V. CONCLUSION
CONCLUSION The Court GRANTS the Motion but denies without prejudice any request to preclude evidence that may be used for multiple purposes. IT IS SO ORDERED....
-
609.5 Surface Hazards
Grab bars and any wall or other surfaces adjacent to grab bars shall be free of sharp or abrasive elements and shall have rounded edges....
-
R409.8 Surfaces
Handrail gripping surfaces and any surfaces adjacent to them shall be free of sharp or abrasive elements and shall have rounded edges....
-
Authoring Tool
Any software, or collection of software components, that can be used by authors, alone or collaboratively, to create or modify content for use by others, including other authors....
-
§27.7(b)(1)(vii)
(vii) Otherwise limit a qualified person with a disability in the enjoyment of any right, privilege, advantage, or opportunity enjoyed by others receiving an aid, benefit, or service....
-
Authoring Tool
Any software, or collection of software components, that can be used by authors, alone or collaboratively, to create or modify content for use by others, including other authors....
-
§104.4(b)(1)(vii)
(vii) Otherwise limit a qualified handicapped person in the enjoyment of any right, privilege, advantage, or opportunity enjoyed by others receiving an aid, benefit, or service....
-
12181(6) Private entity
(6) Private entity The term "private entity" means any entity other than a public entity (as defined in section 12131(1) of this title)....
-
409.4.3 Platform to Hoistway Clearance
The clearance between the car platform and the edge of any landing sill shall be 1½ inch (38 mm) maximum....
