In order for mirrors to be usable by people who are ambulatory and people and people who use wheelchairs, the top edge of mirrors should be 74 inches (1880 mm) minimum from the floor or...
Search Results "Minimum Dimension"
-
603.3 Mirrors
-
1134A.5, Item 5
When glass is used, it shall have minimum thickness of not less than 1/8 inch (3.17 mm) when fully tempered, or 1/4 inch (6.35 mm) when laminated, and shall pass the test requirements of...
-
1134A.6, Item 7
When glass is used, it shall have minimum thickness of not less than 1/8 inch (3.17 mm) when fully tempered, or ¼ inch (6.35 mm) when laminated, and shall pass the test requirements of this...
-
11B-308.3.1 Unobstructed
allows a parallel approach to an element and the side reach is unobstructed, the high side reach shall be 48 inches (1219 mm) maximum and the low side reach shall be 15 inches (381 mm) minimum...
-
11B-224.4 Guest rooms with communication features
TABLE 11B-224.4 GUEST ROOMS WITH COMMUNICATION FEATURES Total Number Of Guest Rooms Provided Minimum Number Of Required Guest Rooms With Communication Features...
-
11B-224.4 Guest rooms with communication features
TABLE 11B-224.4 GUEST ROOMS WITH COMMUNICATION FEATURES TOTAL NUMBER OF GUEST ROOMS PROVIDED MINIMUM NUMBER OF REQUIRED GUEST ROOMS WITH COMMUNICATION FEATURES...
-
11B-303.3 Beveled
Changes in level between ¼ inch (6.4 mm) high minimum and ½ inch (12.7 mm) high maximum shall be beveled with a slope not steeper than 1:2. Advisory 11B-303.3 Beveled....
-
11B-812.7.2 Marking
Access aisle markings may extend beyond the minimum required length....
-
11B-603.3 Mirrors
In order for mirrors to be usable by people who are ambulatory and people who use wheelchairs, the top edge of mirrors should be 74 inches (1880 mm) minimum from the floor or ground. ◼...
-
Passing Spaces [1017.4]
used or the trail is not at the same level as the adjoining ground surface, such as a bridge crossing a ravine, increasing the frequency of passing spaces or widening the tread width to a minimum...
-
M301.2.1, M302.2.1 Transfer Height
M301.2.1, M302.2.1 Transfer Height Proposed requirement: The height of the transfer surface during patient transfer shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum...
-
11B-232.1 General
correctional facilities shall comply with the 2010 Standards except that public entities shall provide accessible mobility features complying with section 807.2 of the 2010 Standards for a minimum...
-
Clear Tread Width and Passing Spaces for Outdoor Recreation Access Routes
The minimum clear tread width of an outdoor recreation access route is 36 inches (915 millimeters), which is wide enough to allow unobstructed passage by a wheelchair....
-
Preliminary Guidelines for Vitri-Turf SEWF Installation
Allow the surface to cure for a minimum of 24 h. Cleanup Clean all tools and surface spots immediately with diesel fuel prior to drying....
-
Eye Height
The AASHTO Guide for the Development of Bicycle Facilities (p. 40) assumes a bicyclist eye height of 140 cm (54 inches) in calculating the minimum length of vertical curve necessary to provide...
-
Width
The AASHTO Guide for the Development of Bicycle Facilities (p. 5) recommends a minimum width of 120 cm (48 inches) for any facility designed to be used by bicyclists.(2) This is based on...
-
11B-232.1 General
correctional facilities shall comply with the 2010 Standards except that public entities shall provide accessible mobility features complying with section 807.2 of the 2010 Standards for a minimum...
-
Assessment factors. (Section-by-Section Analysis)
The NPRM proposed the following specific assessment factors: (1) The dimensions, weight, and operating speed of the mobility device in relation to a wheelchair; (2) the potential risk of...
-
Door King Inc. 1837 PC Programmable Telephone Entry and Access Control System
Dimensions Surface Mount: 13"H x 11.25"W x 4.75"D. Dimensions Flush Mount: 13.25"H x 12"W x 3.25"D. Dimensions Wall Mount: 15"H x 13.25"W x 3.5"D....
-
1118B.3
If gratings have elongated openings, then they shall be placed so that the long dimension is perpendicular to the dominant direction of travel (see Figure 11B-7E)....
-
3.3.1 Research Data
Access Board staff asked Clive D’Souza and Edward Steinfeld to reanalyze the AWM Project data to examine the adequacy of proposed transfer surface dimensions (30” x 15”) as a static seating...
-
III-7.2100 Equivalent facilitation
For instance -- 1) In altered areas, elevator car dimensions can be smaller than the standards would mandate for new construction (§4.1.6(3)(c)); 2) Rather than install a text telephone...
-
Table of Contents
CHAPTER 1: APPLICATION AND ADMINISTRATION 101 Purpose 102 Dimensions for Adults and Children 103 Equivalent Facilitation 104 Conventions 105 Referenced Standards 106 Definitions...
-
AJW Architectural Products U526 Series U526-10 Sanitary Napkin/Tampon Dispenser - 10 cent Operation - Recessed
Flange will adjust from a 1" minimum to a 6" maximum wall depth....
