The height of transfer platforms shall be 11 inches (280 mm) minimum and 18 inches (455 mm) maximum measured to the top of the surface from the ground or floor surface....
Search Results "Curb Ramp Surface"
Filters
Commonly Searched Documents
-
1008.3.1.2 Height
-
R405.2.1 General
Space under an element between the finish surface and 230 mm (9 in) above the finish surface shall be considered toe clearance and shall comply with R405.2....
-
11B-1008.3.1.2 Height
The height of transfer platforms shall be 11 inches (279 mm) minimum and 18 inches (457 mm) maximum measured to the top of the surface from the ground or floor surface....
-
11B-1008.3.1.2 Height
The height of transfer platforms shall be 11 inches (279 mm) minimum and 18 inches (457 mm) maximum measured to the top of the surface from the ground or floor surface....
-
11B-1008.3.1.2 Height
The height of transfer platforms shall be 11 inches (279 mm) minimum and 18 inches (457 mm) maximum measured to the top of the surface from the ground or floor surface....
-
Purpose
Purpose For many years, the National Center on Accessibility (NCA) at Indiana University received questions from organizations, agencies and individuals on how to make natural surface...
-
Circulation Path
An exterior or interior way of passage provided for pedestrian travel, including but not limited to, walks, hallways, courtyards, elevators, platform lifts, ramps, stairways, and landings...
-
E1-d
Where the slope of the accessible route is greater than 1:20, does this area meet the following requirements for an accessible ramp? Yes No...
-
106.5.19 Circulation Path
An exterior or interior way of passage provided for pedestrian travel, including but not limited to, walks, hallways, courtyards, elevators, platform lifts, ramps, stairways, and landings...
-
III-7.5110 Stairs
Interior and exterior stairs must comply if they go between levels not connected by an elevator, ramp, or lift....
-
705.1.3 Contrast
Detectable warning surfaces shall contrast visually with adjacent walking surfaces either light-on-dark, or dark-on-light. Figure 705.1 Size and Spacing of Truncated Domes...
-
1133A.3 Removable base cabinets
Sinks and work surfaces required by Section 1133A.4 (see Item 1 and Item 2) shall be provided with knee and toe space complying with Section 1133A.7....
-
1133A.3 Removable base cabinets
Sinks and work surfaces required by Section 1133A.4 (see Item 1 and Item 2) shall be provided with knee and toe space complying with Section 1133A.7....
-
TechnoGym® - Radiant Inclusive Commercial Fitness System
New features that improve the accessibility of the Radiant Inclusive: swing away seats, single-handed adjustments, ramps on the top, and a step to easily approach the machines....
-
1008.3.1.2 Height
The height of transfer platforms shall be 11 inches (280 mm) minimum and 18 inches (455 mm) maximum measured to the top of the surface from the ground or floor surface....
-
407.3.1 Identification
Where provided, key surfaces outside active areas of the display screen shall be raised above surrounding surfaces....
-
Overview
The project would involve the installation of 5‒7 different test surfaces in various regions of the country with periodic testing and evaluation of those surfaces by local trained operators...
-
Soiltac Powder Mix-In
Soiltac Powder Mix-in is applied to the surface with a spreader, tilled, smoothed, and then compacted. It is then sprayed to seal the surface....
-
9. Platform lift
Platform lift 4.11 May be used in lieu of an elevator or ramp under certain conditions....
-
10.2.2(1)
(1) Bus stop sites shall be chosen such that, to the maximum extent practicable, the areas where lifts or ramps are to be deployed comply with section 10.2.1(1) and (2)....
-
§ 38.29(a)
(a) Interior handrails and stanchions shall permit sufficient turning and maneuvering space for wheelchairs and other mobility aids to reach a securement location from the lift or ramp....
-
AJW Architectural Products U127 40 oz. Vertical Liquid Soap Dispenser w/ Push-up Valve - Surface Mounted
Product Features Fabricated of #20 gauge stainless steel with #4 satin finish A refill indicator displays remaining product Holds 40 fl oz. of liquid soap or hand...
-
AJW Architectural Products U840 Dual Hooded Toilet Tissue Dispenser w/Auto Reserve - Surface Mounted - Non-Controlled
Product Features Fabricated of #22 gauge stainless steel with a #4 satin finish. Holds two standard toilet tissue rolls. Secured with pin tumbler lock, keyed like all AJW...
-
Limitations
Visitor use may have impact on the surface conditions. It is impossible to control the number of children using any given public playground. ...
