The height of transfer device seats shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
Search Results "Curb Ramp Surface"
-
11B-1002.6.2 Transfer height
-
11B-705.1.2.1 Platform edges
Detectable warning surfaces at platform boarding edges shall be 24 inches (610 mm) wide and shall extend the full length of the public use areas of the platform....
-
11B-812.8.7 Location
Signs shall be 60 inches (1525 mm) minimum above the finish floor or ground surface measured to the bottom of the sign....
-
11B-812.8.7 Location
Signs shall be 60 inches (1525 mm) minimum above the finish floor or ground surface measured to the bottom of the sign....
-
§35.150 Existing facilities (Section-by-Section Analysis)
ramps or other sloped areas at any intersection having curbs or other barriers to entry from a street level pedestrian walkway, and all newly constructed or altered street level pedestrian...
-
Elevated Play Components
Play areas with 20 or more elevated components must use ramps to connect a minimum of 25 percent of those components. ...
- Access Board: Sales and Service Counters
-
Side Reach [§308.3]
Fuel Dispensers The operable parts of fuel dispensers located on existing curbs can be up to 54” high....
- AJW Architectural Products U133 56 oz. One-Piece Liquid Soap Dispenser - Surface Mounted
- AJW Architectural Products U115 32 oz. Stainless Steel Powder Soap Dispenser - Surface Mounted
- AJW Architectural Products U109 16 oz. Plastic Bulb Liquid Soap Dispenser - Surface Mounted
- AJW Architectural Products U199 Series Lever Operated, ABS Roll Towel Dispenser - Surface Mounted
- AJW Architectural Products U134EA 33 fl oz. Automatic Liquid Soap Dispenser - Surface Mounted
- Gamco Surface Mounted Horizontal Tank Type Soap Dispenser with All-Purpose Valve - G-58AP
- AJW Architectural Products U1512EA High Speed Automatic 120 Volt Hand Dryer - Surface Mounted
- Gamco Surface-Mounted Vertical Tank Type Soap Dispenser with All-Purpose Valve - G-16AP
- Wooster Products Flex-Tred Anti-Slip Tape
-
810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
Sloped Entries: ADA Standard Section 1009.3.1
EXCEPTION: Where sloped entries are provided, the surfaces shall not be required to be slip resistant....
-
Treatment of Data
and compare across surface types....
-
1133B.5.4.5
SECTION 1133B GENERAL ACCESSIBILITY FOR ENTRANCES, EXITS AND PATHS OF TRAVEL 1133B.5 Ramps. 1133B.5.4.5 Landing width. ...
-
Treatment of Data
Treatment of Data The research design for this study was developed to collect data on surface conditions, evaluate surface performance, note deficiencies and compare results across surface...
-
EXIT
Exit components include exterior exit doors at the level of exit discharge, interior exit stairways, interior exit ramps, exit passageways, exterior exit stairways and exterior exit ramps...
- Bradley Verge Lavatory Systems
