Sloped Entries Sloped entries must comply with ADAAG accessible route provisions (36 inch minimum width, maximum 1:12 or 8.33% slope), except that the surface does not need to be slip...
Search Results "Clear Width at Turn"
-
Sloped Entries
-
Ramp
The ramp had a constant width of 30 inches and was 1 inch thick. The minimum length was 8 inches and the maximum length was 11 inches....
-
11B-405.7.5 Doorways
Doors, when fully open, shall not reduce the required ramp landing width by more than 3 inches (76 mm)....
-
Platform Edges
Where this breakaway material is installed at a platform edge, the width of the detectable warning surface can begin at the edge of the breakaway material rather than at the edge of the...
-
36 Inch Wide Stalls
A 36-inch width (absolute) allows the parallel grab bars to be used simultaneously when changing from a standing position to a seated position and vice versa....
-
Trailhead Signs
designed for use by hikers or pedestrians, the final rule requires the signs to include information on the length of the trail or trail segment; surface type; typical and minimum tread width...
-
1016.5 Obstacles
Where possible, obstacles that cross the full width of outdoor recreation access routes should be separated by a distance of 48 inches (1220 mm) minimum....
-
1009.6.3 Size
Such wheelchair spaces shall not reduce the means of egress minimum width or required capacity....
-
11B-405.7.5 Doorways
Doors, when fully open, shall not reduce the required ramp landing width by more than 3 inches (76 mm)....
-
§ 38.23(d)(4) Orientation
wheelchair or mobility aid facing forward, or rearward with a padded barrier, extending from a height of 38 inches from the vehicle floor to a height of 56 inches from the vehicle floor with a width...
-
1009.6.3 Size
Such wheelchair spaces shall not reduce the means of egress minimum width or required capacity....
-
Technical Memorandum TM 2017-25 Door and Gate Surfaces
This smooth surface must extend the full width of the door or gate....
-
Exemptions for Entire Trail or Beach Access Route
for trails when: The combination of running slope and cross slope exceeds 40 percent for over 20 feet; A trail obstacle 30 inches high or more runs across the full tread width...
-
1.1.13 Flatness of ramp running slope
For ramps over 5 ft (1525 mm) in width between handrails measure along an additional line for each additional 36 in. (915 mm) of width or fraction thereof beyond 5 ft (1525 mm)....
- Stop Signs and More Disabled Passenger Loading Zone Only Sign
- Rockwood Manufacturing Company 603 Door Guard - Cast Aluminum
- Magnuson Group VALUTA Waste Receptacles
-
Executive summary
The minimum length and width included in the clear floor space requirements located adjacent to the ride seat or transfer device do not accommodate many wheeled mobility device users....
- Allegion Von Duprin 98/99 Series AX Intro Video
- AJW Architectural Products U1525EA Series Automatic 120 Volt Hand Dryer, White Powder Coat - Surface Mounted
-
608.2.2 Standard Roll-In Type Shower Compartments
Standard roll-in type shower compartments shall be 30 inches (760 mm) wide minimum by 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
Basic Features
Careful planning and design will incorporate elements such as a wider entrance door, adequate clear floor space, appropriate placement and models of fixtures and furniture, and grab bars...
-
802.1.4 Approach
Because accessible routes serving wheelchair spaces are not permitted to overlap the clear floor space at wheelchair spaces, access to any wheelchair space cannot be through another wheelchair...
-
7(2)(a)(i)
Doors may swing into the clear floor space provided at any fixture if the maneuvering space is provided....