This seat requires a minimum of 2" tub ledges to rest on (both sides). Folds up easily when not in use. Measures 29" W x 15" D x 21"D....
Search Results "Patient in Side-Lying Position"
Commonly Searched Documents
- Access-Able Designs Tub Transfer Bench SH-414-LR
- Headphones with Microphone (BE9133)
- Sloan Sensor Activated Ultra-Fast Drying Xlerator Hand Dryer EHD-501
- American Specialties Folding Utility Shelf for Toilet Compartments 0698
-
Re: Service Counters
intent of this section of the code is to provide not only an accessible counter surface for the disabled to utilize, but also to allow a free flow interaction with an employee on the other side...
- DORMA KTC-2 Revolving Door
- Cybex Total Access Cable Column Exercise Machine
-
11B-235.2 Boat slips
For example, a single pier 25 feet (7620 mm) long and 5 feet (1525 mm) wide (the minimum width specified by Section 11B-1003.3) allows boats to moor on three sides....
-
8.6 Persons "Regarded As" Addicts and Illegal Drug Users
example: If an employer perceived someone to be addicted to illegal drugs based upon rumor and the groggy appearance of the individual, but the rumor was false and the appearance was a side-effect...
-
1009.5.7 Grab Bars
Grab bars shall comply with 609 and be located on at least one side of the transfer system. The grab bar located at the transfer platform shall not obstruct transfer....
-
704.4.1 Height
accessible telephone because the required 34 inches (865 mm) minimum keypad height can causes the highest operable part of the telephone, usually the coin slot, to exceed the maximum permitted side...
-
Handrails Requirement
The Board has included provisions in section 505 that exempt walking surfaces from requirements for handrails on both sides and from requirements for handrail extensions....
-
Ambulatory Accessible Compartment
The width of ambulatory compartments is specified to ensure that the grab bars required on both sides are simultaneously within reach....
-
604.7 Dispensers
If toilet paper dispensers are installed above the side wall grab bar, the outlet of the toilet paper dispenser must be 48 inches (1220 mm) maximum above the finish floor and the top of...
-
704.4.1 Height
accessible telephone because the required 34 inches (865 mm) minimum keypad height can causes the highest operable part of the telephone, usually the coin slot, to exceed the maximum permitted side...
-
R309.4 Curb Ramps or Blended Transitions
At parallel parking spaces, curb ramps and blended transitions should be located so that a van side-lift or ramp can be deployed to the sidewalk and the vehicle occupant can transfer to...
-
T702.4 Character Height
Table T702.4—Character Height Sign location Minimum character height Exterior route or destination signs on boarding side of non-rail...
-
704.4.1 Height
accessible telephone because the required 34 inches (865 mm) minimum keypad height can causes the highest operable part of the telephone, usually the coin slot, to exceed the maximum permitted side...
-
407.12.3 Forward Reach (Section-by-Section Analysis)
) would thus be new to the existing 508 Standards, it nonetheless would provide greater design flexibility by permitting controls to be configured for forward reach (or, alternatively, side...
-
A4.1.3(19)(a)
For example, a marker which contrasts (light on dark or dark on light) and which also reflects light could be placed on the side of such seating so as to be visible in a lighted auditorium...
-
Obstructions [4.7.8]
Where space at the top is less than 48 inches, side flares must have a maximum slope of 1:12 instead of 1:10 at the curb face....
-
Grab Bars [4.20.4] and Controls [4.20.5]
Seats at the head of the tub are limited to a 15 inch depth so that back support is available from the side wall (which is why grab bars cannot be placed on the seat wall)....